HP Manager Software manual Unconfigured, But that are not configured on any WX switches

display dap unconfigured 297

	See Also
	„ display {ap dap} config on page 277
	„ display dap connection on page 294
	„ display dap unconfigured on page 297
	„ set dap on page 77
	„ set {ap dap} bias on page 310
display dap	Displays Distributed MAPs that are physically connected to the network
unconfigured	but that are not configured on any WX switches.
	Syntax — display dap unconfigured
	Defaults — None.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — This command also displays an MAP that is directly connected
	to an WX switch, if the WX port to which the MAP is connected is
	configured as a network port instead of a MAP access port, and if the
	network port is a member of a VLAN.
	If a Distributed MAP is configured on an WX switch in another Mobility
	Domain, the MAP can appear in the output until the MAP is able to
	establish a connection with an WX switch in its Mobility Domain. After
	the MAP establishes a connection, the entry for the MAP ages out and no
	longer appears in the command’s output.
	Entries in the command output’s table age out after two minutes.

Examples — The following command displays information for two

Distributed MAPs that are not configured:

WX1200# display dap unconfigured
Total number of entries: 2			Port	Vlan
Serial Id	Model	IP Address
-------------	------	---------------	----	--------
M9DE48B012F00	AP2750	10.3.8.54	5	default
M9DE48B123400	AP2750	10.3.8.57	6	vlan-eng