HP Manager Software manual See Also „ display ap dap config on

set {ap dap} blink 311

MAP selection of an WX switch is sticky. After a MAP selects an WX switch to boot from, the MAP continues to use that switch for its active data link even if another switch configured with high bias for the MAP becomes available.

Examples — The following command changes the bias for a Distributed

MAP to low:

WX4400# set dap 1 bias low success: change accepted.

See Also

„display {ap dap} config on page 277

set {ap dap} blink Enables or disables LED blink mode on a MAP access point to make it easy to identify.

When blink mode is enabled on an AP2750, the 11a LED blinks on and off.

When blink mode is enabled on an AP3750, the health and radio LEDs alternately blink green and amber.

When blink mode is enabled on an AP7250, the Radio LED flashes red and the Power LED flashes green/orange. The Ethernet LED does not change.

When blink mode is enabled on an AP8250, the Radio LED flashes red and the Power LED flashes green/orange. The Ethernet LED does not change.

When blink mode is enabled on an AP8750, both Radio LEDs flash red and the Power LED flashes green/orange. The Ethernet LED does not change.

When blink mode is enabled on other models (MAP-xxx), the health and radio LEDs alternately blink green and amber. By default, blink mode is disabled.