HP Manager Software manual Syntax set ip snmp server enable disable

152CHAPTER 6: IP SERVICES COMMANDS

Examples — The following command adds a default route that uses gateway 10.5.4.1 and gives the route a cost of 1:

WX4400# set ip route default 10.5.4.1 1 success: change accepted.

The following commands add two default routes, and configure MSS to always use the route through 10.2.4.69 when the interface to that gateway router is up:

WX4400# set ip route default 10.2.4.69 1 success: change accepted.

WX4400# set ip route default 10.2.4.17 2 success: change accepted.

The following command adds an explicit route from a WX switch to any host on the 192.168.4.x subnet through the local router 10.5.4.2, and gives the route a cost of 1:

WX4400# set ip route 192.168.4.0 255.255.255.0 10.5.4.2 1 success: change accepted.

The following command adds another explicit route, using CIDR notation to specify the subnet mask:

WX4400# set ip route 192.168.5.0/24 10.5.5.2 1 success: change accepted.

See Also

„clear ip route on page 118

„display interface on page 126

„display ip route on page 131

set ip snmp server Enables or disables the SNMP service on the wireless LAN switch.

Syntax — set ip snmp server {enable disable}

enable — Enables the SNMP service. disable — Disables the SNMP service.

Defaults — The SNMP service is disabled by default.

Access — Enabled.