HP Manager Software manual „ auth-type none md5 sha auth-pass-phrase string

set snmp usm 175

„ip ip-addr— ID is based on the IP address of the station running the management application. Enter the IP address of the station. MSS calculates the engine ID based on the address.

„local — Uses the value computed from the switch’s system IP address.

„access {read-only read-notify notify-only read-write notify-read-write}

Specifies the access level of the user:

„read-only— An SNMP management application using the string can get (read) object values on the switch but cannot set (write) them.

„read-notify— An SNMP management application using the string can get object values on the switch but cannot set them. The switch can use the string to send notifications.

„notify-only— The switch can use the string to send notifications.

„read-write— An SNMP management application using the string can get and set object values on the switch.

„notify-read-write— An SNMP management application using the string can get and set object values on the switch. The switch can use the string to send notifications.

„auth-type {none md5 sha} {auth-pass-phrase string

auth-keyhex-string}

Specifies the authentication type used to authenticate communications with the remote SNMP engine. You can specify one of the following:

„none—No authentication is used.

„md5—Message-digest algorithm 5 is used.

„sha—Secure Hashing Algorithm (SHA) is used.

If the authentication type is md5 or sha, you can specify a passphrase or a hexadecimal key.