HP Manager Software manual Syntax set snmp protocol v1 v2c usm all enable disable

172CHAPTER 6: IP SERVICES COMMANDS

set snmp protocol Enables an SNMP protocol. MSS supports SNMPv1, SNMPv2c, and SNMPv3.

Syntax — set snmp protocol {v1 v2c usm all} {enable disable}

„v1 — SNMPv1

„v2c — SNMPv2c

„usm — SNMPv3 (with the user security model)

„all — Enables all supported versions of SNMP.

„enable — Enables the specified SNMP version(s).

„disable — Disables the specified SNMP version(s).

Defaults — All SNMP versions are disabled by default.

Access — Enabled.

History —Introduced in MSS Version 4.0.

Usage — SNMP requires the switch’s system IP address to be set. SNMP will not work without the system IP address.

You also must enable the SNMP service using the set ip snmp server command.

Examples — The following command enables all SNMP versions:

WX-1200# set snmp protocol all enable success: change accepted.

See Also

„set ip snmp server on page 152

„set snmp community on page 160

„set snmp notify target on page 162

„set snmp profile on page 167

„set snmp security on page 173

„set snmp usm on page 174

„display snmp status on page 191