HP Manager Software manual Set snmp trap, Set snmp usm, Community strings

174CHAPTER 6: IP SERVICES COMMANDS

„set snmp protocol on page 172

„set snmp usm on page 174

„display snmp status on page 191

set snmp trap	This command is deprecated in MSS Version 4.0. To enable or disable
	SNMP notifications, configure a notification profile. See set snmp
	profile on page 167.
set snmp trap	This command is deprecated in MSS Version 4.0. To configure an SNMP
receiver	notification target (also called trap receiver), see set snmp notify target
	on page 162.
set snmp usm	Creates a USM user for SNMPv3.
	This command does not apply to SNMPv1 or SNMPv2c. For these SNMP
	versions, use the set snmp community command to configure
	community strings.
	Syntax — set snmp usm usm-username
	snmp-engine-id {ip ip-addrlocal hex hex-string}
	access {read-only read-notify notify-only read-write
	notify-read-write}
	auth-type {none md5 sha}
	{auth-pass-phrase string auth-key hex-string}
	encrypt-type {none des 3des aes}
	{encrypt-pass-phrase string encrypt-key hex-string}
	„ usm-username— Name of the SNMPv3 user. Specify between 1 and
	32 alphanumeric characters, with no spaces.
	„ snmp-engine-id {ip ip-addrlocal hex hex-string} —
	Specifies a unique identifier for the SNMP engine.
	To send informs, you must specify the engine ID of the inform
	receiver. To send traps and to allow get and set operations and so on,
	specify local as the engine ID.
	„ hex hex-string— ID is a hexadecimal string.