HP Manager Software manual Mp-352mp-372- MAP access point model, WX1200# set port trap 3-4 enable

set port type ap 87

Examples — The following command enables SNMP linkup and linkdown traps on ports 3 and 4:

WX1200# set port trap 3-4 enable

See Also

„display snmp configuration on page 136

„set ip snmp server on page 152

„set snmp community on page 160

„set snmp profile on page 167

„set snmp notify target on page 162

set port type ap Configures an WX switch port for an MAP access point.

CAUTION: When you set the port type for MAP use, you must specify the PoE state (enable or disable) of the port. Use the WX switch’s PoE to power 3Com MAP access points only. If you enable PoE on a port connected to another device, physical damage to the device can result.

Before configuring a port as an MAP access point port, you must use the set system countrycode command to set the IEEE 802.11 country-specific regulations on the WX switch. See “set system countrycode” on page 54.

For an MAP that is indirectly connected to the WX switch through an intermediate Layer 2 or Layer 3 network, use the set dap command to configure a Distributed MAP.

Before changing the port type from ap to wired-author from wired-authto ap, you must reset the port with the clear port type command.

Syntax — set port type ap port-listmodel {ap2750 ap3750 ap7250 ap8250 ap8750 mp-52 mp-101 mp-122 mp-241 mp-252 mp-262 mp-341 mp-352mp-372}

poe {enable disable} [radiotype {11a 11b 11g}]

„port-list— List of physical ports.

„model {ap2750 ap3750 ap7250 ap8250 ap8750 mp-52

mp-101 mp-122 mp-241 mp-252 mp-262 mp-341

mp-352mp-372}— MAP access point model: