HP Manager Software Following command loads configuration file testconfig1, WX4400# load config

552CHAPTER 18: FILE MANAGEMENT COMMANDS

Syntax — load config [url]

„url — Filename. Specify between 1 and 128 alphanumeric characters, with no spaces.

If the file is in a subdirectory, specify the subdirectory name, followed by a forward slash, in front of the filename. For example: backup_configs/config_c.

Defaults — The default file location is nonvolatile storage.

The current version supports loading a configuration file only from the switch’s nonvolatile storage. You cannot load a configuration file directly from a TFTP server.

If you do not specify a filename, MSS uses the same configuration filename that was used for the previous configuration load. For example, if the WX switch used configuration for the most recent configuration load, MSS uses configuration again unless you specify a different filename. To display the filename of the configuration file MSS loaded during the last reboot, use the display boot command.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — This command completely replaces the running configuration with the configuration in the file.

Examples — The following command reloads the configuration from the most recently loaded configuration file:

WX4400# load config

Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n) [n]y

success: Configuration reloaded

The following command loads configuration file testconfig1:

WX4400# load config testconfig1

Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n) [n]y

success: Configuration reloaded