HP Manager Software manual Output for display ip https, WX4400# display ip https

130CHAPTER 6: IP SERVICES COMMANDS

Examples — The following command shows the status and port number for the HTTPS management interface to the WX switch:

WX4400# display ip https

HTTPS is enabled

HTTPS is set to use port 443

Last 10 Connections:
IP Address	Last Connected	Time Ago (s)
------------	----------------------- ------------
10.10.10.56	2003/05/09 15:51:26 pst	349

Table 30 describes the fields in this display.

Table 30 Output for display ip https

Field	Description
HTTPS is	State of the HTTPS server:
enabled/disabled	„	Enabled
	„	Disabled

HTTPS is set to use port TCP port number on which the WX switch listens for

HTTPS connections.

Last 10 connections	List of the last 10 devices to establish connections to
	the WX switch’s HTTPS server.
IP Address	IP address of the device that established the
	connection.
	If a browser connects to a WX switch from behind a
	proxy, then only the proxy IP address is shown. If
	multiple browsers connect using the same proxy, the
	proxy address appears only once in the output.
Last Connected	Time when the WX switch established the HTTPS
	connection to the WX switch.
Time Ago (s)	Number of seconds since the device established the
	HTTPS connection to the WX switch.

See Also

„clear ip telnet on page 119

„display ip telnet on page 133

„set ip https server on page 150

„set ip telnet on page 156

„set ip telnet server on page 157