HP Manager Software manual WX1200# set ap 4 group none success change accepted

314CHAPTER 9: MANAGED ACCESS POINT COMMANDS

„dap dap-num— Number of a Distributed MAP to add to the group.

„dap auto —Configures blink mode for the MAP configuration template. (See set dap auto on page 306.)

„name — MAP access point group name of up to 16 alphanumeric characters, with no spaces.

Defaults — MAP access points are not grouped by default.

Access — Enabled.

History —Introduced in MSS Version 3.0. MSS Version 4.0 added auto option for configuration of the MAP configuration template.

Usage — You can assign any subset or all of the MAP access points connected to an WX switch to a group on that switch. All access points in a group must be connected to the same WX switch.

If you use the name none, spelled in any combination of capital or lowercase letters, the specified MAP access point is cleared from all MAP access point groups.

Examples — The following command configures an MAP access point group named loadbalance1 that contains the MAP access points on ports 1, 3, and 5:

WX1200# set ap 1,3,5 group loadbalance1 success: change accepted.

The following command removes the MAP access point on port 4 from all

MAP access point groups:

WX1200# set ap 4 group none success: change accepted.

See Also

„display {ap dap} config on page 277

„display {ap dap} group on page 285