HP Manager Software manual Overview

1	USING THE COMMAND-LINE
	INTERFACE

	This chapter discusses the 3Com Wireless Switch Manager (3WXM)
	command-line interface (CLI). Described are the CLI conventions (see “CLI
	Conventions” on page 24), editing on the command line (see
	“Command-Line Editing” on page 29), using the CLI help feature (see
	“Using CLI Help” on page 31), and information about the command
	descriptions in this reference (see “Understanding Command
	Descriptions” on page 32).
Overview	Mobility System Software (MSS) operates a 3Com Mobility System
	wireless LAN (WLAN) consisting of 3Com Wireless Switch Manager
	(3WXM) software and 3Com Wireless LAN Switch or 3Com Wireless LAN
	Controller (WX switch) and 3Com Wireless LAN Managed Access Point
	(MAP) hardware. There is a command-line interface (CLI) on the WX
	switch that you can use to configure and manage the WX and its
	attached access points.
	You configure the wireless LAN switches and access points primarily with
	set, clear, and display commands. Use set commands to change
	parameters. Use clear commands to reset parameters to their defaults. In
	many cases, you can overwrite a parameter with another set command.
	Use display commands to show the current configuration and monitor
	the status of network operations.

The wireless LAN switches support two connection modes:

„Administrative access mode, which enables the network administrator to connect to the WX switch and configure the network

„Network access mode, which enables network users to connect through the WX switch to access the network