HP Manager Software manual Set boot, Configuration-file, Testconfig1, Backupconfigs/configc

558CHAPTER 18: FILE MANAGEMENT COMMANDS

	Examples — The following command saves the running configuration to
	the configuration file loaded during the most recent reboot. In this
	example, the filename used during the most recent reboot is
	configuration.
	WX4400# save config
	Configuration saved to configuration.
	The following command saves the running configuration to a file named
	testconfig1:
	WX4400# save config testconfig1
	Configuration saved to testconfig1.
	See Also
	„ display boot on page 547
	„ display config on page 548
	„ load config on page 551
set boot	Changes the configuration file to load after rebooting.
configuration-file	Syntax — set boot configuration-file filename
	„ filename — Filename. Specify between 1 and 128 alphanumeric
	characters, with no spaces.
	To load the file from a subdirectory, specify the subdirectory name,
	followed by a forward slash, in front of the filename. For example:
	backup_configs/config_c.
	Defaults — The default configuration filename is configuration.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — The file must be located in the switch’s nonvolatile storage.
	Examples — The following command sets the boot configuration file to
	testconfig1:

WX4400# set boot configuration-file testconfig1 success: boot config set.