![](/images/new-backgrounds/1106345/10634587x1.webp)
CHAPTER 1 Product Outline
1.4Console
Serial Terminal
If your GP7000F has no local graphic console, a serial terminal, such as Personal Computer, should be attached to the GP7000F in order to install the system and to run diagnostic programs. To attach a serial terminal :
Connect a terminal data cable to serial port A on your server.
Set a terminal to receive 8bit per character, 1 stop bit and no parity at 9600 baud.
Refer to the document accompanying your terminal for more information about the terminal itself.
Terminal break command
You can disable to enter the OpenBoot mode from break command and keyboard STOP+A command, by the following proceedings.
set
1To display current setting, type
ok
2To disable break command and keyboard STOP+A command, type as below. ok
3To make sure the settings, type
ok
To enable the break command and STOP+A command, use the following command at the ok prompt. Note that the commands are enabled as the default of the GP7000F.
4To display currrent setting, type
ok
5To enable break command and keyboard STOP+A command, type as below. ok
6To make sure the setting, type
ok
CAUTION
If used improper commands at the ok prompt, the GP7000F may be destroyed. If you need to used any other commands except shown on this manual, you should well understand the function and usage of the command before using it.
10