Fujitsu M600R, M200R, GranPower7000 (GP 7000F), M400R manual System to shutdown or destroy data

Task	Warning
System Installation	Install "Basic Software Extension" or "Enhanced Support
	Facility"before operating the system. Without this package,
	incorrect front panel operations and hardware errors may cause
	the system to shutdown or destroy data.
Disk Expansion Unit	Be sure to replace the power supply fan when installing the
Installation	Disk Expansion Unit. Otherwise, the system will shutdown or
	disk units will deteriorate due to a temperature rise in the
	M200 main cabinet caused by insufficient cooling.
Disk Expansion Unit	If the installing location (slot) is not set or set
Installation	incorrectly, the disk drive may not be hot-swappable.
	Data may be destroyed as a result of inadvertently replacing
	the different disk drive. Be sure to set the installing
	location (slot) correctly.
	Also, while replacing or initializing NVRAM, set the
	installing location again.
Normal Operation	Do not set the AC main line switch to OFF, not disconnect
	the power cable or RCI cable while the GP7000F main cabinet
	is powered on, unless absolutely necessary. Otherwise, the
	data may be destroyed in the disk units.
Normal Operation	Do not set the AC main line switch to OFF, nor disconnect
	the power cable or RCI cable while the GP7000F main cabinet
	is powered on, unless absolutely necessary. Otherwise, the
	data in the disk units may be destroyed.
Replacing Disk Drives	When replacing the disk unit,take the following precautions.
	If these precautions are not observed, the disk unit or its
	data may be destroyed.
Formatting Disk Drives	Carefully proceed formatting a disk drive. Once formatting
	a disk drive, data on the disk never restored, if you don't
	have backup files.
Handling Floppy Disks	Do not eject a floppy disk while the access LED is on, other
	wise the floppy disk or the data on the diskette may be
	destroyed.
	For information on the handling method, see Table 11.2,
	"Handling floppy disks."
Ejecting DAT cartridge	Data destruction: Do not press the eject switch during an
	operation (when the tape LED is blinking). If the eject
	switch is held down for about 5 seconds or pressed 3 times
	within a 5 minutes period, the forced ejection function may
	execute and the data being written may be destroyed.
Handling DAT cartridge	When using the data cartridge (DAT), take the following
	precautions. If these precautions are not observed, the
	DAT unit or its data may be destroyed.
Storing 8-mm cartridge	When using or storing the data cartridge, take the following
	precautions. If these precautions are not taken, the data
	on 8-mm tape may be destroyed.
Ejecting QIC cartridge	Data destruction: Do not press the eject switch during an
	operation. The forced ejection function may operate and
	data being written may be destroyed.
Storing QIC cartridge	When using or storing the data cartridge, take the following
	precautions. If these precautions are not taken, the QIC
	tape unit or its data may be destroyed.

ix