Sharp LC-40LE830U, LC-52LE830U Precautions when transporting the TV, Caring for the cabinet

Page 6

IMPORTANT SAFETY INSTRUCTIONS

Outdoor Antenna Grounding — If an outside antenna is connected to the television equipment, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges.

Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE, ANSI/NFPA 70

 

 

ANTENNA

 

 

LEAD IN WIRE

 

GROUND

ANTENNA

 

CLAMP

 

DISCHARGE UNIT

 

 

 

 

(NEC SECTION 810-20)

ELECTRIC

 

 

SERVICE

 

GROUNDING

EQUIPMENT

 

CONDUCTORS

 

 

(NEC SECTION 810-21)

 

 

GROUND CLAMPS

 

 

POWER SERVICE GROUNDING

 

 

ELECTRODE SYSTEM

 

 

(NEC ART 250, PART H)

NEC — NATIONAL ELECTRICAL CODE

Water and Moisture — Do not use this product near water - for example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like.

Stand — Do not place the product on an unstable cart, stand, tripod or table. Placing the product on an unstable base can cause the product to fall, resulting in serious personal injuries as well as damage to the product. Use only a cart, stand, tripod, bracket or table recommended by the manufacturer or sold with the product. When mounting the product on a wall, be sure to follow the manufacturer's instructions. Use only the mounting hardware recommended by the manufacturer.

Selecting the location — Select a place with no direct sunlight and good ventilation.

Ventilation — The vents and other openings in the cabinet are designed for ventilation. Do not cover or block these vents and openings since insuffi cient ventilation can cause overheating and/or shorten the life of the product. Do not place the product on a bed, sofa, rug or other similar surface, since they can block ventilation openings. This product is not designed for built-in installation; do not place the product in an enclosed place such as a bookcase or rack, unless proper ventilation is provided or the manufacturer's instructions are followed.

The front panel used in this product is made of glass. Therefore, it can break when the product is dropped or applied with impact. Be careful not to be injured by broken glass pieces in case the panel breaks.

Heat — The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifi ers) that produce heat.

The Liquid Crystal panel is a very high technology product with 2,073,600 pixels, giving you fi ne picture details. Occasionally, a few non-active pixels may appear on the screen as a fi xed point of blue, green, red or yellow. Please note that this does not affect the performance of your product.

Lightning — For added protection for this television equipment during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the equipment due to lightning and power-line surges.

Power Lines — An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

To prevent fi re, never place any type of candle or fl ames on the top or near the TV set.

• To prevent fi re or shock hazard, do not place the AC cord under the TV set or other heavy items.

• Do not display a still picture for a long time, as this could cause an afterimage to remain.

• To prevent fi re or shock hazard, do not expose this product to dripping or splashing. No objects fi lled with liquids, such as vases, should be placed on the product.

Do not insert foreign objects into the product. Inserting objects in the air vents or other openings may result in fi re or electric shock. Exercise special caution when using the product around children.

Precautions when transporting the TV

When transporting the TV, never carry it by holding or otherwise putting pressure onto the display. Be sure to always carry the TV by two people holding it with two hands — one hand on each side of the TV.

Caring for the cabinet

Use a soft cloth (cotton, fl annel, etc.) and gently wipe the surface of the cabinet.

Using a chemical cloth (wet/dry sheet type cloth, etc.) may deform the components of the main unit cabinet or cause cracking.

Wiping with a hard cloth or using strong force may scratch the surface of the cabinet.

If the cabinet is very dirty, wipe with a soft cloth (cotton, fl annel, etc.) soaked in neutral detergent diluted with water and thoroughly wrung out, and then wipe with a soft dry cloth.

Avoid using benzene, thinner, and other solvents, as these may deform the cabinet and cause the paint to peel off.

Do not apply insecticides or other volatile liquids.

Also, do not allow the cabinet to remain in contact with rubber or vinyl products for a long period of time. Plasticizers inside the plastic may cause the cabinet to deform and cause the paint to peel off.

4

Image 6
Contents LC-40LE830U LC-46LE830U LC-52LE830U LC-60LE830U Page Model No To aid reporting in case of loss or theft, please recordFCC Compliance Statement Industry Canada StatementAdditional Safety Information Dear Sharp CustomerPrecautions when transporting the TV Caring for the cabinetChild Safety Caring for the front panelContents LC-40LE830U Supplied AccessoriesAttaching the Stand Insert the stand into the openings on the rear of the TVLC-60LE830U LC-46LE830U/LC-52LE830UInsert the stand into the openings on the rear Stand into the openings on the rearRemote control sensor Using the Remote Control UnitInsert the batteries into the remote control unit. See AC outletPreparation Installing Batteries in the Remote Control UnitConnecting Antenna Cable AntennasPart Names TV FrontTV Rear Remote Control Unit Part NamesTypes of Connection Introduction to ConnectionsExperiencing HD Images Displaying an External Equipment ImageWhen using DVI-HDMI conversion cable Hdmi Connecting to External EquipmentWhen using Hdmi cable Hdmi 1, 2, 3 or Back panel vertical inputsWhen using Composite cable Video 1 or Connecting to External EquipmentWhen using Component cable Component Back panel surface inputsConnecting an Audio Amplifier Connecting an AV AmplifierMm stereo minijack cable Connecting a PCWhen using analog RGB cable PC Back panel Surface inputsWatching TV Turning On/Off the Power Initial InstallationLanguage Language setting TV LocationCH Search Channel search Air/Cable Antenna settingWatching TV Antenna & Cable/STB To watch TV via a set-top boxExamples of the settings confirmation screen Watching TV CompletedDirect Button Operation Changing VolumeSleep Timer Changing ChannelsDirect Button Operation Press Power SavingExample When the input source is TV, COMPONENT, Video 1 or Press InputExamples Closed Captions and Digital Closed CaptionsPress CC This will present the Closed Caption information displayFor HD programs Press View ModeYou can select the screen size For 43 programsOn-Screen Display Menu Operation Using the remote controlOn-Screen Display Menu Menu Operation ButtonsMenu Items On-Screen Display MenuOPC Setting Picture SettingsAV Mode Changing Pic.Quality Advanced Picture SettingsGamma Adjustment Color Temp Color TemperatureFine tuning the color temperature Film Mode 32 pull-downSurround Audio SettingsAuto Volume Bass EnhancerNo Signal Off Power ControlPower Saving Audio OnlySystem Options View OptionInput Terminal Setting Menu DesignCaption Setup Icon Light Up SettingDemo Mode Game Play TimeBroadcasting Setup Initial SetupEZ Setup CH SetupIndividual Setup ResetWall Mount Audio Setup LanguageChip is an electronic fi ltering device built into your When setting an individual content-based rating itemChip TV Parental GuidelinesCanadian French Ratings How to temporarily release the V-CHIP BlockCanadian English Ratings Reactivating the temporarily released V-CHIP BlockIdentification Software UpdateInformation Digital Caption Info Digital Caption InformationUpdating the Software via the Network Call 1-800-BE-SHARPDuring the data checking, Checking blinks Press Enter to start checking the data in the USBMemory device Select Yes, and then press Enter After the screen shown below is displayed, pressEnjoying Photo/Music/Video Playback Connecting a USB Memory Device/USB Hard DriveConnecting a Home Network Dlna Server Ethernet cableEnjoying Photo/Music/Video Playback When displaying the data with the AppsSelect the Files to Play Back USB memory devicePhoto Mode Playing Back Files on a USB Memory DeviceSelect Slide Show BGM USB MenuSelect Slide Show Interval Buttons for slide show BGM select operationButtons for playing mode Buttons for music mode Music ModeVideo Mode Set/Reset All Auto PlayUSB Menu Menu for file selecting operations Using the operation panelMenu for playing mode Title/ChapterUSB Device Compatibility DivX SetupPress a/b to select DivX Setup, and then press Enter DivX VOD registration DivX VOD deregistrationButtons Description C/d Playing Back Files on a Home Network Dlna ServerHome Network Dlna Menu Yellow Display the Home Network Dlna Menu ScreenButtons for playing mode Home Network Dlna Server CompatibilityOther Viewing Options Presetting Remote Control FunctionPresetting manufacturer codes Operating the Connected EquipmentOther Viewing Options Manufacturer codes Using Aquos Link Controlling Hdmi Equipment Using Aquos LinkUsing Aquos Link Aquos Link SetupOne Touch Playback Start/Stop Recording Link Operation MenuOne Touch Recording Displaying the Link Operation MenuPlayback of Titles Using Aquos Link Using the Device Operation PanelTimer Recording Manually Changing Aquos Audio Speaker System’s Sound ModeUsing a PC Displaying a PC Image on the ScreenStretch Dot by Dot PC Compatibility Chart Adjusting the PC ImageSetting Audio Input Using a PCControl of the TV Using a PC Command table Commands not indicated here are not guaranteed to operateUsing an Ethernet cable Using the InternetConnecting to the Internet About the original homeUsing the Internet Using the wireless LANWireless Setup Internet SetupInteractive Service Checking Your Internet ConnectionSetting the Zip Code Displaying Updated Information and Support ServiceSetting the Country Original HomeEntering Text Software Keyboard Using the Browser Featured ContentAbout links Selected item Description Select This Using the Toolbar Using TabsSelected item Close This TabSaving the URL of the Current Opening a BookmarkedEditing Bookmarks Browser Settings Security SettingsView Settings Using Applications via the Internet Deactivating Netflix FunctionDeactivating the Vudu Function Disclaimers Before detaching or attaching the stand, unplug the AC cord AppendixRemoving the Stand LC-60LE830U Before attaching/detaching the standAppendix Setting the TV on the WallOptional Accessories Hanging on the wallTroubleshooting Pages 24Pages 27 E202 Troubleshooting Error MessageError code Possible Solution Displayed on a screen E203CH Setup Broadcasting Setup Initial Setup menuSoftware Update Information menu TrademarksSpecifications Model LC-40LE830U Model LC-46LE830UReceiving Digital Terrestrial 69ch Function Channel SpecificationsModel LC-52LE830U Model LC-60LE830U Digital cable*1Wireless LAN SpecificationSoftware developed by Sharp and open source software Information on the Software License for This ProductSoftware composition Obtaining source codeInformation on the Software License for This Product Software CopyrightsCalling for Service Limited WarrantyDimensional Drawings AN-37AG2 + AN-37P30AN-52AG4 LC-52LE830U Sharp Electronics Corporation