Watching TV
Daily operation
Selecting an external video source
Switching on/off
Turning on/off the power
Press a on the TV.
Switch it off by pressing a on the TV.
NOTE
Once the connection is made, press b to display the “INPUT SOURCE” screen, and then press a/b to switch over to the appropriate external source with OK.
INPUT SOURCE
TV
EXT1
EXT2
EXT3
EXT4
HDMI1
• When turning off the power using a on the TV, EPG data will be lost, and programmed timer recordings will not be performed by the TV.
* The terminal layout may differ depending on the model.
Standby mode
E To standby mode
If the TV is switched on, you can switch it to standby by pressing B on the remote control unit.
E Switching on from standby
From standby, press B on the remote control unit.
TV indicator status
B indicator | Status |
|
|
Off | Power off |
|
|
Green | Power on |
|
|
Red | Standby |
|
|
NOTE
•If you are not going to use this TV for a long period of time, be sure to remove the AC cord from the AC outlet.
•A small amount of electric power is still consumed even when a is turned off.
Switching between analogue and digital broadcasts
E Watching digital | E Watching analogue |
broadcasts | broadcasts |
Changing channels
With Pr/s: | With |
Selecting a sound mode
E DTV mode:
If multi sound modes are received, each time you press 2 the mode switches as follows.
Audio (ENG) : STEREO
L/R L R LR
Audio (ENG) : CH A
CH A | CH B | CH AB | |
|
|
|
Audio (ENG) : MONO
Press c/d to select L or R sound when the STEREO or DUAL MONO screen is displayed.
Audio (ENG) : STEREO
L/R | L | R | LR |
|
|
|
|
NOTE
•The sound mode screen disappears in six seconds.
•Selectable items vary depending on the received broadcasts.
E ATV mode:
Each time you press 2, the mode switches as shown in the following tables.
| NICAM TV broadcasts selection | |
Signal |
| Selectable items |
Stereo |
| NICAM STEREO, MONO |
Bilingual |
| NICAM CH A, NICAM CH B, NICAM CH AB, MONO |
Monaural |
| NICAM MONO, MONO |
| A2 TV broadcasts selection | |
Signal |
| Selectable items |
Stereo |
| STEREO, MONO |
Bilingual |
| CH A, CH B, CH AB |
Monaural |
| MONO |
NOTE
• When no signal is input, the sound mode will display “MONO”.
10