Sharp LC-32SV1E Child Lock, Input Label, Fine Sync, Changing the PIN, Resetting the PIN

Press MENU and the MENU screen displays. Press c/dto select “Setup”.

Press b to select the desired input source. Press MENU and the MENU screen displays.

Menu operations

Child Lock TV only

Allow you to use a PIN to protect certain settings from being accidentally changed.

Changing the PIN

1

2

3 Press a/bto select “Child Lock”, and then press OK.

Change PIN

Reset

New PIN
	–	–	–	–
Reconfirm	–	–	–	–

4 Enter the 4-digit number as a PIN using 0 – 9.

5 Enter the same 4-digit number as in step 4 to confirm.

•“The system PIN has been changed successfully” displays.

NOTE

•To view a locked channel (Lock setting in Programme Setup “Manual Adjust” is set to “On”), you must enter a PIN. (See page 15.) When you select a locked channel, a PIN prompt message pops up. Press OK to display the PIN input window.

Resetting the PIN

Allow you to reset your PIN to the factory preset “1234”.

1 Repeat steps 1 to 3 in Changing the PIN.

2 Enter the PIN.

3 Press a/bto select “Reset”, and then press OK. 4 Press c/dto select “Yes”, and then press OK.

NOTE

•As a precautionary measure, make a note of your PIN on the back of this operation manual, cut it out and keep it in a safe place that children cannot reach.

•See page 21 for resetting the current PIN to the factory preset “1234” if you lose or forget your PIN.

Input Label

You can assign each input source a label you like.

1

2

3 Press c/dto select “Setup”.

4 Press a/bto select “Input Label”, and then press OK.

5 Press a/b/c/dto select each character of the new name for the input source, and then press

OK.

6 Repeat step 5 above until the name is fully spelt out, and then press OK.

•The name can be 6 characters or less.

•If a label name is less than 6 characters, select “END”, then press OK.

NOTE

• You cannot change the label if the input source is TV.

Fine Sync. PC only

Menu Operation: C (Page 11)

Ordinarily, the TV automatically adjusts image positions coming from PC (Auto Sync. function). In some cases, however, manual adjustment is needed to optimise the image.

Item

H-Pos.:Centres the image by moving it to the left or right.

V-Pos.:Centres the image by moving it up or down.

Clock: Adjusts when the image flickers with vertical stripes.

Phase: Adjusts when characters have low contrast or when the image flickers.

NOTE

•If you need to adjust the image position, adjust the position using your PC.

16