Conguring Your TV’s Settings

Balance: This setting is used for emphasizing left or right speaker balance.

Headphone: Sets headphone volume.

Sound Mode: You can select Mono, Stereo, Dual I or Dual II mode, only if the selected channel supports that mode.

AVL:Automatic Volume Limiting (AVL) function sets the sound to obtain xed output level between programmes (For instance, volume level of advertisements tend to be louder than programmes).

Digital Out: Sets digital out audio type.

Detailed settings can be configured to suit your personal preferences.

Press “MENU” button and select Settings icon by using “” or “” button. Press OK button to view Settings menu.

Operating Settings Menu Items

•Press “” or “” button to highlight a menu item.

•Press OK button to select an item.

•Press “MENU” button to exit.

Settings Menu Items

Conditional Access: Controls conditional access modules when available.

Language: Congures language settings.

Parental: Congures parental settings.

Timers: Sets timers for selected programmes.

Date/Time: Sets date and time.

Sources: Enables or disables selected source options.

Network Settings: Displays Network Settings screen.

Other Settings: Displays other setting options of the TV set.

Using a Conditional Access Module

IMPORTANT: Insert or remove the CI module only when the TV is SWITCHED OFF.

•In order to watch certain digital channels, a conditional access module (CAM) can be necessary. This module must be inserted in the CI slot of your TV.

•Obtain the Conditional Access Module (CAM) and the viewing card by subscribing to a pay channel company, then insert those to the TV using the following procedure.

•Insert the CAM and then the viewing card to the slot that is located in the terminal cover at the rear side of the TV.

•The CAM should be correctly inserted, it is impossible to insert fully if reversed. The CAM or the TV terminal may be damaged if the CAM is forcefully inserted.

Connect the TV to the mains supply, switch on and then wait for few moments until the card is activated.

•When no module is inserted, “No Common Interface module detected” message appears on the screen.

•Refer to the module instruction manual for details of the settings.

Viewing Conditional Access Menu (*)

(*)These menu settings may change depending on the service provider.

Press “MENU” button and select the icon by using “ ” or “” button. Press OK button to view Settings menu. Use “” or “” button to highlight Conditional

Access and press OK to view menu items.

English - 30 -