Channel memory setting, Antenna Setup Digital

Sharp LC-19D45U Channel memory setting, When viewing Analog broadcasts, Antenna Setup Digital

Basic adjustment settings

Channel memory setting

	1	Press MENU to display the MENU screen, and
	1	then press c/d to select “Setup”.
		then press c/d to select “Setup”.
	2	Press a/b to select “CH Setup”, and then
	2	press ENTER.
		press ENTER.
	3	Press a/b to select “CH Memory”, and then
	3	press ENTER.

4	Press ENTER.

5	When viewing ANALOG broadcasts:

1Press c/d to select the channel to skip, and then press b to move down.

2Press c/d to select “On”, and then press

ENTER.

•On: Skips channels. (Channel selection disabled using CH r/s.)

•Off: Does not skip channels. (Channel selection enabled using CH r/s.)

When viewing DIGITAL broadcasts:

1Press a/b to select the channel to skip, and then press ENTER to select “ADD” or “ERASE”.

•ERASE: Skips channels. (Channel selection disabled using CH r/s.)

•ADD: Does not skip channels. (Channel selection enabled using CH r/s.)

6	Press MENU to exit.

• Make sure what kind of connection is made to your TV.

Antenna Setup Digital

In order to receive digital air broadcasts, you need a digital broadcast antenna. You can conﬁ rm the antenna conﬁ guration through the “Antenna Setup DIGITAL” screen.

If necessary, adjust the direction of the antenna to obtain the maximum signal strength.

Signal Strength

	1	Press MENU to display the MENU screen, and
	1	then press c/d to select “Setup”.
		then press c/d to select “Setup”.

	2	Press a/b to select “CH Setup”, and then
	2	press ENTER.
		press ENTER.
	3	Press a/b to select “Antenna Setup Digital”,
	3	and then press ENTER.
		and then press ENTER.
	4	Press a/b to select “SIGNAL STRENGTH”.
	4

•The signal strength of DIGITAL channel is displayed. The signal information is based on the current channel.

	SIGNAL STRENGTH
	CHANNEL STRENGTH	Adjust the antenna until
	CHANNEL STRENGTH	the level is 60 or higher
		the level is 60 or higher
		str

5	Press MENU to exit.

•This "SIGNAL STRENGTH" display is a standard to decide the best direction of the antenna, and cannot to guarantee image/voice.

Channel Strength

	1	Press MENU to display the MENU screen, and
	1	then press c/d to select “Setup”.
		then press c/d to select “Setup”.
	2	Press a/b to select “CH Setup”, and then
	2	press ENTER.
		press ENTER.
	3	Press a/b to select “Antenna Setup Digital”,
	3	and then press ENTER.
		and then press ENTER.
	4	Press a/b to select “CHANNEL STRENGTH”,
	4	and then press ENTER.
		and then press ENTER.

•Input the 2-digit channel number to check the strength of the selected channel.

•Make sure the appropriate signal strength of each

channel received is obtained.

SIGNAL STRENGTH

CHANNEL STRENGTH

5	Press MENU to exit.