Sharp LC-19D45U Useful adjustment settings, Auto Sync. Adjustment for Analog PC input mode only

Useful adjustment settings

Auto Sync. Adjustment (for Analog PC input mode only )

This function enables the screen to be automatically adjusted to its best possible condition when the analog terminals of the TV and PC are connected with a commercially available RGB cable, etc.

1	Press MENU and the MENU screen displays.
2	Press c/d to select “Setup”.
3	Press a/b to select “PC Setup”, and then
	press ENTER.
4	Press a/b to select “Auto Sync.”, and then
	press ENTER.
5	Press a/b to select “Yes”, and then press
	ENTER.
	• Auto Sync. starts.
	Input Signal
	Auto Sync.	Yes
	Fine Sync.
		No

6 Press MENU to exit.

NOTE

•Auto Sync. is likely to succeed when an input PC image has wide vertical stripes (e.g. pattern with high contrast stripes, or cross-hatched).

It may fail when an input PC image is solid (low contrast).

•Be sure to connect the PC to the TV and switch it on before starting Auto Sync.

Fine Sync. Adjustment

Ordinarily you can easily adjust the picture as necessary to change image position using Auto Sync. In some cases, however, manual adjustment is needed to optimism the image.

1	Press MENU and the MENU screen displays.
2	Press c/d to select “Setup”.
3	Press a/b to select “PC Setup”, and then
	press ENTER.
4	Press a/b to select “Fine Sync.”, and then
	press ENTER.
5	Press a/b to select “Yes”, and then press
	ENTER.
6	Press a/b to select a specifi c adjustment
	item among “H-Pos.”, “V-Pos.”, “Clock” and
	“Phase”.
		H-Pos.	[ 90]	a	b
		V-Pos.	[ 60]	a	b
		Clock	[ 90]	a	b
		Phase	[ 8]	a	b
		Reset

Selected item		Description
H-Pos.		Centres the image by moving it to the left
		or right.
V-Pos.		Centres the image by moving it up or
		down.
Clock		Adjusts when the image fl ickers with
		vertical stripes.
Phase		Adjusts when characters have low
		contrast or when the image fl ickers.
7	Press c/d to adjust the item to your desired
	position.
8	Press MENU to exit.

NOTE

•For resetting all adjustment items to the factory preset values, press a/b to select “Reset”, and then press

ENTER.

•Images may not be displayed properly depending on the settings and/or input signals.

33