Option menu (Continued)
H Audio only
When listening to music from a music programme, you can set the display off and enjoy audio only.
Selected item | Description |
|
|
On | Audio is output without screen image. |
|
|
Off | Both screen images and audio are output. |
|
|
NOTE
•When you make operations that change the picture on the TV such as by changing the input source, the Audio only function is set to “Off”.
H Game play time
This function displays the elapsed game time so you do not lose track of the time.
To display the elapsed time, select “GAME” under
“AV mode” for the input mode of the terminal connected to the game console before starting the game.
Selected item | Description |
|
|
On | The elapsed time is displayed every |
| 30 minutes when you switch to GAME |
| mode in external input mode. |
Off | Hides the time. |
|
|
H Colour system
You can change the colour system to one that is compatible with the image on the screen. (Auto, PAL, SECAM, NTSC 3.58, NTSC 4.43,
NOTE
•If “Auto” is selected, colour system for each channel is automatically set. If an image does not display clearly, select another colour system (e.g. PAL).
•“Colour system” is selectable only when inputting an
H Fine sync. (PC input mode only)
Adjusting the PC image automatically
Auto sync.
This function enables the screen to be automatically adjusted to its best possible condition when the analogue terminals of the TV and PC are connected with a commercially available RGB cable, etc.
NOTE
•Auto sync. is likely to succeed when an input PC image has wide vertical stripes (e.g. pattern with high contrast stripes, or
It may fail when an input PC image is solid (low contrast).
•Be sure to connect the PC to the TV and switch it on before starting Auto sync.
Adjusting the PC image manually
Ordinarily you can easily adjust the picture as necessary to change image position using Auto sync. In some cases, however, manual adjustment is needed to optimise the image.
Selected item | Description |
|
|
Centres the image by moving it to the left | |
| or right. |
|
|
Centres the image by moving it up or | |
| down. |
|
|
Clock | Adjusts when the image fl ickers with |
| vertical stripes. |
Phase | Adjusts when characters have low contrast |
| or when the image fl ickers. |
NOTE
•For resetting all adjustment items to the factory preset values, press a/b to select “Reset”, press ENTER, press c/d to select “Yes”, and then press ENTER.
•Images may not be displayed properly depending on the settings and/or input signals.
Input signal
•Some input signals may have to be registered manually to display properly.
•The pairs of input signals (resolutions) in the list below are not distinguishable when received. In such case, you have to set the correct signal manually. After setting once, it will display when the same signal (resolution) is input again.
1280 g 768 | 1360 g 768 |
H Version up
This function is only for service personnel to use for software updates.
15