Sharp LC-22LE250K Slow Forward, Timeshift Recording, Instant Recording, Recording Configuration

Page 14
Timeshift Recording

Note: Recorded programmes are saved into the connected USB disk. If desired, you can store/copy recordings onto a computer; however, these files will not be available to be played on a computer. You can play the recordings only via your TV.

Note: Lip Sync delay may occur during the timeshifting. Radio record is supported. The TV can record programmes up to ten hours.

Recorded programmes are split into 4GB partitions.

If the writing speed of the connected USB disk is not sufficient, the recording may fail and the timeshifting feature may not be available.

It is recommended to use USB hard disk drives for recording HD programmes.

Do not plug out the USB/HDD during a recording. This may harm the connected USB/HDD.

Multipartition support is available. The maximum of two different partitions are supported. The first partition of the USB disk is used for PVR ready features. It also must be formatted as the primary partition to be used for the PVR ready features.

Some stream packets may not be recorded because of signal problems, so sometimes video may freezes during playback.

Record, Play, Pause, Display (for PlayListDialog) keys can not be used when teletext is ON. If a recording starts from timer when teletext is ON, teletext is automatically turned off. Also teletext usage is disabled when there is an ongoing recording or playback.

Timeshift Recording

Press Instant RecordingWatching Recorded Programmes (PAUSE) button while watching a broadcast to activate timeshifting mode.In timeshifting mode, the programme is paused and simultaneously recorded to the connected USB disk. Press Slow Forward (PLAY) button again to resume the paused programme from where you stopped. Press the STOP button to stop timeshift recording and return to the live broadcast.

Note: Timeshift cannot be used while in radio mode.

Note : You cannot use the timeshift fast reverse feature before advancing the playback with the fast forward option.

Instant Recording

Press (RECORD) button to start recording an event instantly while watching a programme. You can

press (RECORD) button on the remote control

again to record the next event on the EPG. In this case, an OSD will be displayed, indicating the programmed events for recording. Press Recording ConfigurationMedia Browser Menu (STOP) button to cancel instant recording.

Note: You can not switch broadcasts or view the Media Browser during the recording mode. While recording a programme or during the timeshifting, a warning message appears on the screen if your USB device speed is not sufficent.

Watching Recorded Programmes

Select the Recordings Library from the Media Browser menu. Select a recorded item from the list (if previously recorded). Press the OK button to view the Play Options. Select an option then press OK button.

Note: Viewing main menu and menu items will not be available during the playback.

Press the Manual background (STOP) button to stop a playback and return to the Recordings Library.

Slow Forward

If you press Manual backgroundManual backgroundManual backgroundManual background (PAUSE) button while watching recorded programmes, the slow forward feature will be available.

You can use Manual background button to slow forward. Pressing Manual background button consecutively will change slow forwarding speed.

Recording Configuration

Select the Recording Configuration item in the Settings menu to configure the recording settings.

Format Disk: You can use Format Disk feature for formatting the connected USB disk. Your pin is required to use the Format Disk feature (default pin is 0000).

IMPORTANT: Note that ALL the data stored on the USB disk will be lost and the disk format will be converted to FAT32 if you activate this feature. If your USB disk malfunctions, you can try formatting the USB disk. In most cases formatting the USB disk will restore normal operation; however, ALL the data stored on the USB disk will be lost in such a case.

Note: If “USB is too slow” message is displayed on the screen while starting a recording, try restarting the recording. If you still get the same error, it is possible that your USB disk does not meet the speed requirements. Try

connecting another USB disk.

Media Browser Menu

You can play photo, music, and movie files stored on a USB disk by connecting it to your TV. Connect a USB disk to one of the USB inputs located on the side of the TV. Pressing the MENU button while in the Media Browser mode will access the Picture, Sound and Settings menu options. Pressing the MENU button

again will exit from this screen. You can set your Media Browser preferences by using the Settings Menu.

Loop/Shuffle Mode Operation

Start playback with

and

TV plays next file and loop

activate

 

the list.

 

 

 

 

Start playback with OK and

the same file will be played in a

activate

 

loop (repeat).

 

 

 

Start playback with OK/

and

the file will be played in a shuffle.

activate

 

 

 

 

 

 

English - 13 -

Image 14
Contents LC-22LE250K LCD COLOUR TELEVISIONOPERATION MANUAL ENGLISHContents Blue Neutral Brown Live SPECIAL NOTE FOR USERS IN THE U.KDANGER IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIANIntroduction FeaturesDear SHARP customer Important safety precautions Precautions when transporting the TVCleaning Power SourcePower Cord Replacement PartsLCD Screen Electrical device not in the hands of childrenRepair Information Package ContentsEnvironmental Information Standby Notifications Connect PowerViewing the TV TV Control button & Operation Inserting the Batteries into the RemoteNotification SpecificationAntenna/Cable Connection TRADEMARK ACKNOWLEDGMENTUsing My Button Viewing remote controlUsing My button TeletextPC to YPbPr Connection Cable Not supplied Viewing the ConnectionsAV Connection Cable supplied To Switch the TV Off To Switch the TV OnTo Switch the TV to Standby Aerial InstallationTimeshift Recording Recording ConfigurationSlow Forward Instant RecordingQuick Menu Advanced Settings TV Menu Features and FunctionsPicture Menu Contents Skin tone can be changed between -5 andOther Settings Displays other setting options of the TV set Sound Menu ContentsSettings Menu Contents VolumeClear Service List Install and Retune Menu ContentsPower Up Mode Hard of HearingUsing the Channel List Software upgrade search via user interface3 AM search and upgrade mode Configuring Parental SettingsTv will not turn on Remote control - does not operateTroubleshooting & Tips Poor pictureSupported File Formats for USB Mode AV and HDMI Signal CompatibilityPC Input Typical Display Modes PhotoDimensional Drawings End of life disposal 1. Sharp Television 2. Stand Cover 3. Stand Installing the StandInstalling the Stand Uninstalling the Stand Uninstalling the StandScrew Dimensions Wall Mounting Screw length = A+B Screw50232539