Sharp TU-T2 operation manual Quick guide, Before turning on the power, Initial auto installation

Quick guide

Before turning on the power

n

RF IN

USB

12V DC - 2A

RF OUT

ETHERNET SPDIF	HDMI	VCR	TV	- +
		o		p

nConnect the antenna (standard DIN45325 plug (IEC 169-2) 75 q coaxial cable)

oConnect the HDMI cable

pConnect the power adapter

Initial auto installation

Place the TV close to the AC outlet, and keep the power plug within reach.

When the Receiver is powered on for the first time after purchase, the first time installation screen appears. Follow the on-screen instructions to search for all available channels.

Confirm the following before turning on the power

EIs the antenna cable connected?

EIs the power adapter connected and plugged in?

EIs the HDMI cable connected between the Receiver and your TV?

1Press a on the Receiver.

• The first time installation screen is displayed.

2Ensure the antenna cable is connected.

3Press OK to start the channel search.

•The Receiver will search for, sort and store all receivable channels.

NOTE

•The first time installation process will be aborted if the Receiver is left unattended for more than 30 minutes before searching for channels.

•After the first time installation has been completed, the default PIN is automatically set to ‘0000’. To change the PIN setting, refer to Page 20.

First Time Installation

Please ensure that an aerial is connected

Then press OK to scan for services

TU-T2_GB.indd 9

9

01/06/2010 16:02:54