Symphonic RSMSD125 owner manual Information Troubleshooting Guide, Problem Solution

2

or

Select “INITIALIZE”.

SETUP

QUICK

CUSTOM

INITIALIZE

3

or

ENTER

Select “YES”.

SETUP

INITIALIZE

Initialize?

NO

YES

Problem

Solution

No power

–Check if the AC power cord is properly connected.

–Unplug the outlet once, and wait for 5-10seconds and then plug it in again

No sound or picture

–Check if the TV is switched on.

–Check the video connection

–Check the VIDEO/AUDIO cable connections to the TV

(See Connection to a TV)

–Set PROGRESSIVE correctly. Turn it on only if your TV has

Progressive Scan and you are using the Component Video connec-

tions between the unit and the TV. Disable Progressive Scan for all

other connections. (See page 6)

Distorted picture

–Sometimes a small amount of picture distortion may appear.

This is not a malfunction.

–Connect the unit directly to the TV.

Completely distorted picture or

–Connect the unit directly to the TV.

black/white picture with DVD

–Make sure the disc is compatible with the unit.

–Check if the INTERLACE/PROGRESSIVE mode is set correctly. See page 6.

No sound or distorted sound

–Adjust the volume.

–Check that the speakers are connected correctly.

No audio at digital output

–Check the digital connections.

–Check if the audio format of the selected audio language matches

your receiver capabilities.

No DTS audio is output

–This unit does not support DTS audio.

This is not a malfunction.

Picture freezes momentarily

–Check the disc for fingerprints/scratches and

during playback

clean with a soft cloth wiping from center to edge.

–Clean the disc

Disc can’t be played

–Clean the disc

–Ensure the disc label is facing up.

–Check if the disc is defective by trying another disc.

–Cancel the parental lock or change the control level.

–Insert a correct disc that plays on this unit.

–Handle a disc with special care so that it does not have fingerprints,

scratches, or dusts on its surface.

No return to start-up screen when disc is removed

–Reset the unit by switching the unit off, then on again.

The unit does not respond to

–Aim the remote control directly at the sensor on the front of the unit.

the remote control

–Reduce the distance to the unit.

–Replace the batteries in the remote control.

–Re-insert the batteries with their polarities (+/– signs) as indicated.

–Tune your radio to an empty AM station so that you hear a lot of

noises. Then, turn the volume up. If you hear some signal sound

from the radio by pressing buttons on the remote control, the

remote control is working.

Buttons do not work or the unit stops

–To completely reset the unit, unplug the AC

responding

cord from the AC outlet for 5-10 seconds.

The unit does not respond to some

–Operations may not be permitted by the disc.

operating commands during playback

Refer to the instructions of the disc.

The unit cannot read

–Use a commonly available cleaning CD/DVD to

CDs/DVDs

clean the lens before sending the unit for repair.

Angle does not switch

–The angle cannot be switched for DVDs which do not contain

multiple angles. In some cases multiple angles are only recorded

for specific scenes.

Playback does not start when the title is selected

–Check the “PARENTAL” setting.

The password for rating level has been forgotten

–Enter the default password “4737”, then your forgotten password

will be cleared

• Some functions are prohibited on some discs.

– 17 –

EN