Programming Remote to Control Cable Box

Connecting Your TV

Programming Remote to Control Cable Box

If your cable box has its own remote to change channels, you will

probably be able to program the TV's remote to control both the TV and

the cable box.

The TV's remote is designed to control several brands of cable boxes. To program the remote, just press CABLE, then SETUP, then the two-digit code number for your brand of cable box. Refer to the chart below to find the code number

for your cable box. Press the ON/OFF button next to confirm

operation.

You may need to try each of the code numbers listed for your brand until you find the one that works.

After the TV's remote is programmed, you'll be able to turn on the cable box by pressing CABLE, then ON/OFE You can change channels on the cable box by

pressing the CHANNEL buttons whenever the remote is in the "cable"

mode. To put the remote in the "cable" mode, press the CABLE button. Press the TV button to put the remote back into the TV mode so the remote buttons will control the TV again.

-(withremote only)

1.Refer to the chart below to find the code number that corresponds to the brand name of your cable box. Keep this number in mind. If more than one number is listed, you may need

to try each one separately until you find the one that works.

2.Press CABLE button on remote.

3.Press SETUP button on remote.

4.Press two number buttons (first one, then the other) to enter the code number for your brand of cable box.

Note: You must press the two number buttons within three seconds of pressing the SETUP button.

5.Point the remote at the cable box and

press the ON/OFF button to test the code number.

•If the right number was entered, the cable box should turn on. Pressing the CHANNEL buttons should then also change channels on the cable box.

•If the cable box does not react to the remote (or if the remote turns on the cable box but does not

change channels), repeat steps I thru 5 with another code number.

Operating Notes:

•After the remote is programmed, it will

turn on the cable box whenever you press CABLE; and then ON/OFF.

•To turn off the cable box, press CABLE, then ON/OFF.

•To change channels on the cable box, press CABLE then CHANNEL up or down.

•You may have to reprogram the remote control if you change its batteries. Try not to press any buttons while changing batteries.

Anvision	.....................................................................................	07,08	Pioneer	18,20
Cablestar		07,08	Randtek	07,08
Eagle		08	RCA	27
Eastern	International	02	Regal	12,13
General	Instrument	04,05,15,23,24,25,30,36	Regency	02
Hamlin		12,13,34	Scientific Atlanta	03,22
Hitachi		37,43	Sylvania	11
Jerrold		04,05,15,23,24,25,30,36	Teknika	06
MACOM		37,43	Texscan	10,11
Magnavox		07,08,19,26,28,29,32,33,40,41	Tocom	17,21
NSC		09	Unika	31
Oak		01,16,38	Viewstar	07,08,19,26,28,29,32,33,40,41
Oak Sigma		16	Zenith	14,42
Panasonic		27,39
Philips		07,08,19,26,28,29,32,33,40,41

Note: Refer to the information sheet packed with your remote control for the latest list of brand names and code numbers. Because this list ts constantly growing, the information sheet packed with your remote control may be a later version of this list and contain additional brands and/or code numbers.

Connecting Your TV

Programming Remote to Control Cable Box

Operating Notes:

07,08