Memorizing channels

This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV’s memory. To use this TV with an antenna, set the Signal Type option to the Air mode. When shipped from the factory, this menu option is in the Cable mode.

Air/Cable selection

1 SelectType”. “Channel ⇒ Auto Ch Memory ⇒ Signal 2 Press or to select “Air” or “Cable”.

Air - VHF/UHF channels

Cable - CABLE TV channels

CH Auto Ch Memory


	Signal Type	Cable
	Automatic Search	Start

NOTE:

• It may take a few seconds for a digital channel picture to appear on screen after being selected.

Automatic Search

1 Select “Channel ⇒ Auto Ch Memory ⇒ Automatic Search”, then press or ENTER.

CH Auto Ch Memory

Signal Type	Cable
Automatic Search	Stop

2 The TV will begin memorizing all the channels available in your area.

• It may take from 15 minutes to 30 minutes to complete memorizing digital cable channels. Depending on the reception condition, a bar display may not advance for several minutes, please be patient.

NOTE:

• Memorizing channels is best accomplished during evening “PRIMETIME” hours, as more stations are broadcasting digital signals. Memorizing channels can only be accomplished while a station is broadcasting a digital signal to set that channel into memory.

• If you are unsure of the digital channels available in your area, you may visit www.antennaweb.org to receive a list based on your address or zip code. Should you require further assistance you may call our toll-free customer service line at 1-800-289-0980.

• New digital channels may be added to your area periodically, it is recommended to perform the “Automatic Search” procedure regularly.

Adding Channel

If you find a new digital channel unregistered, you can add the new channel into the channel memory.

1 Tune in the new channel.

2 Select “Channel ⇒ Add/Delete ⇒ Adding Channel”, then press or ENTER.

CH Add/Delete

Adding Channel	>>
Add/Delete	>>
Clear All	>>

3 The new channel will be added into the channel memory.

Add/Delete channel

You can select the channel that you want to skip.

Select “Channel ⇒ Add/Delete ⇒ Add/Delete”,
1 then press				or ENTER.
Press			or	to select the channel that you
2 want to skip.
	CH	Add/Delete
		CH		Signal
			2	Analog	Add
			3	Analog	Add
			3-1	Digital	Delete
			3-2	Digital	Add
			4	Analog	Delete
3
3	Press		or	to select “Add” or “Delete”, whichever

function you want to perform.

4 Repeat steps 2 - 3 for other channels you want to add or delete.

Clear All

All channels are deleted from the channel memory. Select “Channel ⇒ Add/Delete ⇒ Clear All”, then press or ENTER.

CH Add/Delete

	Adding Channel	>>
	Add/Delete	>>
	Clear All	>>

EN 18