Sansui SLED2282 Using an AV Amplifier with built-in digital surround, Monitor Display modes

To return to normal mode Press INPUT SELECT again.

Connections to other equipment (continued)

Using an AV Amplifier with built-in digital surround

If you are using an AV Amplifier with built-in digital surround sound, you can enjoy various audio systems including Dolby Digital Surround audio that sounds just like the movie.

Connect an AV amplifier with built-in Dolby Digital decoder, etc. as shown below. Rear of the unit

To DIGITAL AUDIO COAXIAL OUT

Coaxial digital cable (not supplied)

Front

Speaker

(Left)

Front

Subwoofer Speaker

(Right)

TV

To Coaxial

Digital Audio Input

AV Amplifier with built-in digital surround decoder as listed above

	Center Speaker
Surround	Surround
Speaker (Left)	Speaker
	(Right)

NOTE:

• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio. There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.

• Digital Audio Output terminal does not output the sounds from devices connected by HDMI.

To connect the TV to a PC (Personal Computer)
BEFORE YOU CONNECT THIS TV TO YOUR PC, CHANGE THE ADJUSTMENT OF YOUR PC’S
RESOLUTION AND REFRESH RATE (60 HZ).
Connect one end of a (male to male) VGA cable to the video cord of the computer and the other end to the VGA
connector PC MONITOR IN on the rear of the TV. Attach the connectors firmly with the screws on the plug. In case
of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the
AUDIO IN connector of the PC/DVI AUDIO IN jack of the TV.You can also connect the PC with HDMI cable.
If you use HDMI cable, you don’t have to connect the audio cord. If you use DVI-to-HDMI cable, please connect
audio cord as same way as VGA cable.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The TV can operate as the computer monitor.				Monitor Display modes
To	Rear and Left of the unit			Mode	Resolution	Refresh rate
				VGA	640x480	60/ 72/ 75 Hz
PC/DVI				VGA	720x400	70Hz
AUDIO				SVGA	800x600	56/ 60/ 72/ 75 Hz
IN				XGA	1024x768	60/ 70/ 75 Hz
				WXGA	1280x768	60Hz
			To HDMI/DVI IN	WXGA	1280x720	60Hz
To PC				WXGA	1360x768	60Hz
MONITOR			HDMI cable (not supplied)	SXGA	1280x1024	60Hz
IN				WXGA+	1440x900	60Hz
		VGA cable (not supplied)		FHD	1920x1080	60Hz

Audio cord (not supplied)

NOTE:

• The on-screen displays will have a different appearance in PC mode than in TV mode.

• If there is no video signal from the PC when the unit is in PC mode, “No signal” will appear on the TV-screen.

• When the PC connected to the HDMI terminal and 1920x1080 resolution (FHD) is selected, the top and bottom, right and left edges of the picture may be hidden on all PICTURE SIZE. In this case, use the PC MONITOR IN jack (VGA cable) is recommended to connect.

• When the PC’s resolution is set to 1920 x 1080/60 Hz (FHD mode), a signal that differs from the FHD signal, which has been confirmed operational on this TV, may appear depending on the PC used. In this case, “Auto Adjust” or other Position Adjustment functions may fail to correct the image position.

To solve this problem, change the PC settings to select another resolution.

ENGLISH

13