Sansui SLED2282 Memorizing channels, Air/Cable selection, Automatic Search, Adding Channel

Page 18
Press ▲ or ▼ to select “Add/Delete”, then press or ENTER.
Select “Channel”, then press or ENTER.

Memorizing channels

This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV’s memory. To use this TV with an antenna, set the Signal Type option to the Air mode. When shipped from the factory, this menu option is in the Cable mode.

Air/Cable selection

1 Select “Channel”, then press or ENTER.

2 Press ▲ or ▼ to select “Auto Ch Memory”, then press or ENTER.

3 Press ▲ or ▼ to select “Signal Type”. 4 Press or to select “Air” or “Cable”.

Air - VHF/UHF channels

Cable - CABLE TV channels

CH Auto Ch Memory

 

Signal Type

Cable

 

 

Automatic Search

Start

 

 

 

 

 

:Select

:Adjust

CABLE CHART

The chart below is typical of many cable system channel allocations.

NOTE:

• It may take a few seconds for a digital channel picture to appear on screen after being selected.

Automatic Search

1 Select “Channel”, then press or ENTER.

2 Press ▲ or ▼ to select “Auto Ch Memory”, then press or ENTER.

3 Press ▲ or ▼ to select “Automatic Search”, then press or ENTER.

CH Auto Ch Memory

Signal Type

Cable

Automatic Search

Stop

Analog Channel Found : 0

Digital Channel Found : 0

Programming Now

:Select

ENTER :Cancel

18

4 The TV will begin memorizing all the channels available in your area.

• It may take from 15 minutes to 30 minutes to complete memorizing digital cable channels. Depending on the reception condition, a bar display may not advance for several minutes, please be patient.

NOTE:

Memorizing channels is best accomplished during evening “PRIMETIME” hours, as more stations are broadcasting digital signals. Memorizing channels can only be accomplished while a station is broadcasting a digital signal to set that channel into memory.

If you are unsure of the digital channels available in your area, you may visit www.antennaweb.org to receive a list based on your address or zip code. Should you require further assistance you may call our toll-free customer service line at 1-800-289-0980.

New digital channels may be added to your area periodically, it is recommended to perform the “Automatic Search” procedure regularly.

Adding Channel

If you find a new digital channel unregistered, you can add the new channel into the channel memory.

1 Tune in the new channel.

2 Select “Channel”, then press or ENTER.

3 Press ▲ or ▼ to select “Add/Delete”, then press or ENTER.

CH Add/Delete

 

Adding Channel

>>

 

 

Add/Delete

>>

 

 

Clear All

>>

 

 

 

 

 

 

:Select

ENTER :Set

4 Press ▲ or ▼ to select “Adding Channel”, then press or ENTER. The new channel will be added into the channel memory.

Add/Delete channel

You can select the channel that you want to skip.

1

2

3 Press ▲ or ▼ to select “Add/Delete”, then press or ENTER.

4 Press ▲ or ▼ to select the channel that you want to skip.

CH Add/Delete

CH

Signal

 

2

Analog

Add

3

Analog

Add

3-1

Digital

Delete

3-2

Digital

Add

4

Analog

Delete

5 :Select :Adjust

Press or to select “Add” or “Delete”, whichever function you want to perform.

6 Repeat steps 4 - 5 for other channels you want to add or delete.

Image 18
Contents Customer Service SERVICE/SERVICE Clientèle Orion Website Site WEB OrionEnglish Location of the required MarkingVoltage surges and built-up static Wire to an antenna discharge unit, sizeTo provide some protection against Charges, of the NationalTune Into Safety Child SafetyIssue This Manufacturer CaresHOW to Handle the LCD Panel CondensationHow to attach the stand How to remove the standLCD Panel Side To USE AC Power FeaturesPower source SAFETY, be Sure to Unplug IT from the AC OutletContents Front Parts and functionsLeft side Right sideRemote control Battery PrecautionsCH Channel Antenna connections To connect TV to a DVD player with Component Video Input Connections to other equipmentTo connect the TV to a VCR To connect the TV to a camcorder, or a TV GameTo connect the TV to a PC Personal Computer Using an AV Amplifier with built-in digital surroundResolution and Refresh Rate 60 HZ Monitor Display modesTo connect a Hdmi or a DVI device to the unit TV operation To select the video input sourceChannel number Quick guide for menu operationChannel number Station name Press MENU. The TV menu screen will appearIcon Selected Items Setup hint Convenience functionsAutomatic Search Memorizing channelsAir/Cable selection Adding ChannelLabeling channels To create channel labelsTo change the password Setting the V-ChipTo register a password To set the V-ChipCC advanced To clear the all V-Chip settingsClosed Caption Or EnterSetting the picture size Reception disturbances IgnitionTroubleshooting Block Noise / Picture FreezeSpecifications AccessoriesGeneral Orion SALES, INC 3471 N. Union DROLNEY, Illinois Memo