Connections to other equipment | (continued) |
Using an AV Amplifier with built-in digital surround
If you are using an AV Amplifier with
Connect an AV amplifier with
To DIGITAL AUDIO COAXIAL OUT
Coaxial digital cable
Front
Speaker
(Left)
Front
Subwoofer Speaker
(Right)
TV
(not supplied) To Coaxial Digital Audio Input
AV Amplifier with
| Center Speaker |
Surround | Surround |
Speaker (Left) | Speaker |
| (Right) |
NOTE:
• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio. There will be no sound output if connected to an AV amplifier with a
To connect the unit to a PC (Personal Computer)
BEFORE YOU CONNECT THIS TV TO YOUR PC, CHANGE THE ADJUSTMENT OF YOUR PC’S RESOLUTION AND REFRESH RATE (60 HZ).
Connect one end of a (male to male) VGA cable to the video cord of the computer and the other end to the VGA connector PC MONITOR IN on the rear of the TV. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the AUDIO IN connector of the PC/DVI AUDIO IN jack of the TV.You can also connect the PC with HDMI cable.
If you use HDMI cable, you don’t have to connect the audio cord. If you use
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The TV can operate as the computer monitor.
Rear of the unit
To PC/DVI AUDIO IN
Audio cord (not supplied)
To HDMI IN
To PC
MONITOR IN
NOTE:
• The
• If there is no video signal from the PC when the unit is in PC mode, “No signal” will appear on the
13