Getting Started, Setup and Connection

GETTING STARTED

SETUP AND CONNECTION

Step 1: Connect Your TV

Connect the cable from your cable system or off-air antenna to the CABLE/ ANTENNA jack on the back of the TV, as shown. Also connect external devices such as a VCR or DVD player to the video and audio jacks.

Step 2: Plug In Your TV

Plug the end of the power cord into the wall outlet, matching the wide blade of the plug with the wide slot in the outlet. Be sure to insert the plug completely.

Step 3: Put Batteries in the Remote Control

1.Remove the battery compartment cover from the back of the remote.

2.Insert batteries as shown, matching the + and – ends of each battery in the compartment.

3.Replace the cover.

Step 4: Turn on the TV

Press the TV button on the remote or POWER on the front panel.

Step 5: Auto Channel Search

Perform an Auto Channel Search (described in the Channel menu section). This will program all active channel into the TV’s channel scan list.

DIPOLE ANTENNA CONNECTION

ANTENNA, CABLE, CABLE BOX OR VCR

CABLE/

ANTENNA

VIDEO AUDIO

TV (Back Panel)

Dipole Antenna (Supplied)

Follow the steps to connect the indoor antenna supplied with your TV (only if you do not connect an outdoor antenna or a cable-TV system).

Insert the antenna base into the pocketed slot on the back of your set. Stand at the back of your set with the antenna twin-lead facing you, and press the base of the antenna into the slot until it locks in place.

Connect the ends of the twin-lead to the Antenna Adapter (supplied).

Connect the Antenna Adapter to the ANTENNA connector on the back of		1
the TV.
Later, after you’ve turned on the TV, adjust the length and position of the		Slot
antenna rods for best reception.		Slot
antenna rods for best reception.
•	For viewing VHF channels, extend the rods fully.
•	For viewing UHF channels, shorten the rods for best reception.

Antenna Adapter (Supplied)

Base

Twin Lead

ANTENNA