RCA 15634620 manual Why You Should Connect This G-LINK Cable, How to Find the Remote Sensor

Connections & Setup

Why You Should Connect This G-LINK Cable

The G-LINK cable enables the GUIDE Plus+ system (the on-screen interactive program guide) to work with your VCR and/or cable box.

Cable Box – If your TV is connected to a cable box you must connect the G-LINK cable to receive TV program listings for your area, and to tune directly to a channel when the program guide is on your TV screen.

VCR – If your TV is connected to a VCR and you don’t connect the G-LINK cable, one-touch VCR recording won’t work. The other features of the guide will work properly.

G-LINK cable

G-LINK wands

How to Find the Remote Sensor

You have to place the G-LINK wands in front of the remote sensor on the VCR and/or cable box. Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor isn’t labeled on your VCR and/or cable box, you need to use the remote control that came with the VCR and/or cable box to locate the sensor.

1.Turn off the VCR and/or cable box.

2.Hold the remote control (not the one that came with your TV, but the one that came with the cable box and/or VCR to which you’re attaching the G-LINK cable) so that it is touching the front of the component.

3.Slowly move the remote control across the front of the component (VCR or cable box) while you press the power button on and off. You must press and release the power button each time you move the remote (holding down the button won’t work).

VCR CABLE BOX

CHANNEL

03

4.When the component turns on, you’ve located the remote sensor.

Placing the G-LINK Wands

Tip

If you don’t have both a cable box and a VCR connected to your TV, just coil the cable of the extra G-LINK wand with a twist tie and leave it behind the TV.

Place the G-LINK wands in front of the remote sensor on your VCR and/or cable box approximately one inch away from the remote sensor (see instructions below).

TV (back panel)

VIDEO		AUDIO
	R	L / MONO
		IN
	R	L
		OUT
		CABLE/
G-LINK		ANTENNA

S-VIDEO

Connect to G-LINK jack on the back of the TV.

	VCR
SENSOR	SENSOR	CHANNEL

03

14 Chapter 1