Sony SAT-A65A, SAT-B65A manual Signal Strength, System Test

Testing your system When you have aligned your dish antenna to the azimuth and elevation angles shown on the Antenna pane:

1.Highlight the Signal tab.

2.Use the button to highlight the Source pull-down menu

3.Signal quality is indicated by a scale at the bottom of the pane and with an audible indication. The frequency and tempo of the tone increase with signal strength.

SIGNAL STRENGTH		Wed, Aug 1	5:14 PM
Antenna
Signal	Signal Strength
VCR	Source	Transponder
Prefs
Test	Satellite 101o (A)	04
New Card
Upgrade	Status: Unlocked
Features	Current: 95	Highest: 95
Exit
Return

4.Highlight the Transponder pull-down menu.

5.You may need to select another transponder to achieve the highest signal indication.

6.Select the transponder providing the best signal.

7.Use the button to highlight the Test tab.

8.Highlight Begin Test and press the SELECT button.

Results appear within a few seconds and should resemble those in the figure. If your test results are much different from those shown in the figures, or you receive no signal indication, refer to page 6.

SYSTEM TEST		Wed, Aug 1	5:12PM
Antenna
Signal		System Test
VCR	Begin Test	Xponder Test
Prefs
Test	Version	: 5317.6
New Card
	Wink Version	: 0.0.0.75
Upgrade
	Signal	:OK
Features	Tuning	:OK
Exit	Phone	:OK
Return
	Access Card	:OK
		(ID 0000-0000-0000)
	Front Panel	:OK

To perform the Transponder test:

1.Move the highlight to the Xponder Test pull-down menu.

2.Press the SELECT button.

Getting started 5