Sony SAT-B65A, SAT-A65A manual Connecting a home entertainment system

Connecting a home entertainment system

The A/V receiver must be turned on in order to send the video signal to your TV.

You can integrate the DIRECTV® Receiver into your entertainment system to take advantage of enhanced audio and video capability. Follow these instructions to connect your DIRECTV Receiver.

•To connect the DIRECTV Receiver to your audio system, use A/V cables to connect the satellite receiver to the audio receiver’s AUDIO IN jacks. Refer to the figures on page 2 for rear panel connector locations.

•Dolby Digital - With the SAT-A65A model, you can enjoy programs that contain a Dolby Digital sound track. We recommend that you listen in surround sound for maximum enjoyment of these programs. You can connect the stereo outputs of the SAT-A65A to a receiver that contains a Dolby Surround Pro Logic decoder. This will provide you with three audio channels in the front and a mono surround channel.

•To take full advantage of Dolby Digital programming, connect the SAT-A65A digital audio output to an external 5.1-channelDolby Digital decoder or receiver. This provides you with three front channels, two independent surround channels, and a sub-woofer channel.

1.Connect the satellite antenna RG-6 coaxial cable to the DIRECTV Receiver’s SATELLITE IN jack.

2.Connect the DIRECTV Receiver’s A/V jacks to the VCR and A/V receiver’s A/V jacks.

3.AUX, optical connection, and digital output connections – If your audio receiver has coaxial or optical digital connectors, connect the appropriate type of cable to the DIRECTV Receiver’s DIGITAL AUDIO OUT (SAT-A65A only) for two-channel digital stereo. If your A/V receiver is also capable of decoding Dolby Digital, use this connection in order to listen in full

5.1-channel surround sound. Additional audio information begins on page 20.

4.Connect the VCR’s A/V OUT jacks to a pair of the A/V receiver’s A/V IN jacks.

5.Connect the A/V receiver’s MONITOR OUT jack to the TV’s VIDEO IN jack.

6.Plug the components into an electrical outlet.

Note: If you have connected a VCR to your entertainment system in a way that routes the satellite receiver’s signal to your VCR before it reaches the TV, you may see a distorted picture if you try to record a copy-protected program. A Can’t Tape symbol in the screen banner identifies these programs. If this occurs, simply stop recording and the picture will automatically correct itself.

10 Adding system components