Sylvania DVR90DEA owner manual Precautions, Laser Safety

Page 2

Before you start

Precautions

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

Laser Safety

This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECI- FIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION: VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. DO NOT STARE INTO BEAM.

LOCATION: INSIDE, NEAR THE DECK MECHANISM.

FCC WARNING- This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

A NOTE ABOUT RECYCLING

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

Make your contribution to the environment!!!

Used up batteries do not belong in the dust bin.

You can dispose of them at a collection point for used up batteries or special waste. Contact your council for details.

For Customer Use:

Read carefully the information located at the back of this unit and enter below the Serial No.Retain this information for future reference.

Model No. _____________________

Serial No. _____________________

2

Image 2
Contents Español Supplied AccessoryEditing Changing Precautions Laser SafetyPrecautions cont’d Before youAvoid the Hazards of Electrical Shock and Fire Installation LocationMaintenance Moisture Condensation WarningTable of contents Features Functional overview Remote control sensor Stop C buttonAC Power Cord TV Antenna OUT jack Disc tray Ment with an S-Video cableFunctional overview cont’d Start Connections Getting started Recording Playing discs SETUP/DISC/CD menu Repeat Details are on Indicates a disc type and a format modeDisplay menu MarkerRecording speed Display messageDisc type Title/Track and Chapter markIf your TV is not compatible with progressive scanning Connection to a TVTo enjoy that high quality picture Connection to a cable box or satellite box Connection to an Audio System AudioThis DVD recorder can record on the following type of discs Remote ControlEasy DVD recording To CloseEasy DVD recording Cont’d Speed ChannelChannel setting Getting channels auto- maticallySelect Channel using K / L Buttons, then press Enter button Channel setting cont’dSelect Manual Preset using Buttons, then press Enter button Adding/deleting chan NelsOutputs main-audio Selecting the TV stereo or SAPOption window will appear Secondary Audio ProgramClock setting Auto Clock SettingSelect Clock Setting using Buttons, then press Enter button Clock setting cont’dManual Clock Setting Press Enter button againButtons, then press Enter Clock menu will appear, then the settings will be activatedSelect OFF using K / L ButtonDaylight Saving Time options will appear Setting the daylight sav- ing timeSelect on or OFF using Buttons, then press Enter button Selecting the TV aspect ratio SETUP/DISC menu will appear ScreenSelect TV Aspect using K Buttons, then press Enter Playback menu will appearRecording speed Information on DVD recordingInformation Restrictions on recordingInformation on copy control You will need to finalize discs when in the followingInformation on DVD recording cont’d Making discs playable in other DVD player FinalizeSettings for the recording format to a blank disc Formatting a discFormatting a disc cont’d Select Auto Chapter usingPress Setup button to exit Setup menu Enter button Option window will appearReformatting a disc When a DVD-R disc is loaded Select a recording speed using REC Speed buttonWhen a DVD-RW disc is loaded Basic recordingXP SP LP Basic recording cont’dChecking the recording picture quality Press REC Monitor button Again to exitTurn on the DVD recorder Tons or number buttons One-touch timer recordingSelect a desired channel to record using CH K / L but Load a recordable discEnter the date using K / L Buttons, then press B button Timer recordingNot set up using K / L but Select the program which isTimer recording cont’d When the recording time is partially overlapped Hints for timer recordingPriority of overlapped settings Prog will start after Prog is complete to be recordedSelect L2 Front, then press Enter button Settings for an external sourceConnection to an external source Select L1 Rear, then press Enter buttonRecording from an external source Settings for an external source cont’dSelect a recording speed using REC Speed button. Refer to Recording speed onFinalizing is complete Finalizing the discsSelect Yes, then press Enter button Select Disc Protect OFF Setting a disc to protectOn using K / L buttons Disc will be protectedInformation on DVD play Press OPEN/CLOSE a but- ton to open the disc tray Basic playbackPlayback Menu / List buttonBasic playback cont’d For MP3 playbackB buttons Playing discs using the disc menuPress Menu / List button Press Menu / List button to exit the menuPress TOP Menu button to exit the title menu Playing discs using the title menuPress TOP Menu button Fast forward / Fast reverse Special playbackResume play Pause Special playback cont’dSkipping TV commercials during play During play, press CM Skip buttonStep by step playback Slow forward / Slow reverse playZoom Marker SetupSelect icon using / B buttons, then press Enter button During play, press Zoom but- tonSearch Using Skip H / G buttonsUsing Display button Title/Chapter searchTime search Search cont’dTrack search Able only in the same track orRandom playback Repeat/Random/Program playbackRepeat play Repeat/Random/Program playback cont’d Select Program Play usingSelect a desired track using K Program playDVD-Video Switching audio soundtrackSelecting the format of audio and video Selecting the format of audio and video cont’d Switching subtitlesSelect Icon using / B Audio menu will appearSwitching camera angles Reducing block noiseGuide to a title list Editing discs with Video modeInformation on disc editing Playback status of the current discEditing original titles Editing discs with VR modeInformation on disc editing cont’d Editing playlistsTitlelist will appear Screen Editing DVD-RW discs in Video modeDeleting titles Edit menu will appearEditing DVD-RW discs in Video mode cont’d Putting names on titlesName you entered will be activated for the title Recording Playing discs EditingSetting or clearing chapter markers Chapter marker will be addedEditing DVD-RW discs in VR mode Original Deleting titlesDeleting parts of titles Editing DVD-RW discs in VR mode Original cont’dSelect Scene Delete using Buttons, then press Enter button Original menu will appearSelect Delete using K / L buttons, then press Enter button Abc 123 @ ! ? Option window will appear. Add Disc using / B buttons, then press Enter buttonSelect Chapter Mark using Buttons, then press Enter button Chapter marker will be added. Add Setting pictures for thumbnailsDelete This operation may take aPicture for thumbnail will be SetErasing the titles, you can protect Setting titles to protectTo prevent accidental editing, or Them from the original menuReleasing titles from protecting Playlist will appear Editing DVD-RW discs in VR mode PlaylistSelect PlayList using / B buttons, then press Enter button Cursor will move to Preview You can check a preview Editing DVD-RW discs in VR mode Playlist cont’dPlaylist menu will appear To exit Disc menu Pleted, press Setup buttonAfter writing to disc is com Disc menu will appear ScreenWhen you finish entering a title Name, press Enter button Disc Edit Playlist Edit Title NamePlaylist menu will appear Tons, then press Enter button You cannot delete the first chapter of each titleChapter marker which you selected will be deleted Delete If a selected picture for aREC Pqrs TUV Wxyz Adding titles to a Playlist To delete a title from Playlist, refer to Deleting titles onPlaylist will be erased Deleting a PlaylistPlaylist can be deleted if no longer needed Editing DVD-R discs You cannot select Chapter MarkEditing DVD-R discs cont’d Select Edit Title Name using K / L buttons, thenSelect Yes using / B but- tons, then press Enter but Ton Changing the Setup menu Tour of the Setup menuSETUP/DISC menu will appear Settings for LanguagePress Setup button to display SETUP/DISC menu Settings for Language cont’d Settings for Display Setup DisplayOSD Background Color Default 1 Green Settings for Display cont’dOSD Background Transparency Default 35% OSD Language Default EnglishSettings for Audio Select a setting using K / L buttons, then Settings for Audio cont’dDigital Out Select a setting using K / L Dynamic Range Control Default onSettings for Parental lock level Settings for Parental lock level cont’d Power TroubleshootingSymptom Remedy PicturePlayback Troubleshooting cont’dRecording/Timer recording/Editing Cause Solution Remote controlError message OthersLanguage code Language CodeGlossary Specifications Fácil grabación de DVD Original y Playlist modo VR ¿Qué son títulos y capítulos?Puede editar lo siguiente de la lista de títulos ¿Qué significa Original o Playlist?Limited Warranty