Sylvania lc320ss8 5Switching Audio Mode, This section describes how to switch the audio language

Page 18

WATCHING TV

5Switching Audio Mode

This section describes how to switch the audio language.

TV

DTV

1Press [AUDIO] to display the currently selected audio mode. While receiving an MTS broadcast, press repeatedly to cycle through the available audio channel.

1Press [AUDIO] to display the currently selected language and the number of available languages.

6-1

English 1/3

6

SAP / STEREO

When all audio are available

SAP / STEREO SAP / MONO

SAP / STEREO

When stereo and monaural audio are available

MONO / STEREO MONO / STEREO

When SAP and monaural audio are available

SAP / MONO SAP / MONO

When only monaural audio is available

	MONO
	(Cannot be switched)
STEREO	: Outputs stereo-audio
SAP	: Outputs second audio program
MONO	: Outputs mono-audio

•The current mode will automatically disappear in 4 seconds.

2Press [AUDIO] repeatedly to cycle through the available audio languages.

English 1/3 Spanish 2/3

Other 3/3

•Available languages differ depending on the broadcast. “Other” is displayed when the audio language cannot be acquired, or the acquired languages are other than English, Spanish or French.

•The current mode will automatically disappear in 4 seconds.

Note:

• Pressing [AUDIO] does not control external audio device.

18

EN

Image 18

Contents To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect Antenna LC320SS8Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV InterferenceQuick start guide Remote control 5Supplied Accessories5Symbols Used in this Manual LocationFeatures ContentsDTV/TV/CATV 5Remote Control Function 5Installing the Batteries5Control Panel Antenna Cable Connection Connection5Basic Connection Connection to Cable Box or Satellite Box5External Device Connection Hdmi ConnectionHDMI-DVI Connection Component Video Cable Connection Video Cable ConnectionVideo Connection Audio Output Connection DigitalAnalog PC Connection Make sure if the unit is connected to antenna or cable Initial Setting5Initial Setup Scanning and memorizing of channels start automatically5Main Menu 5Auto Channel Scan5Language Selection EnterWatching TV 5Volume AdjustmentWhat is the minor channel? 5Channel Selection5Still Mode 5Switching Each ModeYou can freeze the image shown on the TV screen Stereo 5Switching Audio ModeThis section describes how to switch the audio language SAPBroadcasting Information 5Screen InformationPress Info Day of Memories5TV Screen Display Mode 5Sleep Timer Press Sleep to set the sleep timerTo Cancel the Sleep Timer Optional Setting 5Channel ListChannel l List Use Cursor K/L to select Manual Register, then press Enter 5Manual Register5Antenna Confirmation Use Cursor K/L to select Antenna, then press Enter5Picture Adjustment Adjust the sound setting 5Sound AdjustmentYou can adjust treble, bass and surround Treble, BassClosed Caption Use Cursor K/L to select DTV CC, then press Enter 5DTV Closed CaptionDTV CC DetaililClosed Captioning font style can be changed as below 5CC StyleFont Style Font SizeBack Color Font ColorFont Opacity Back OpacityChip New Password DpageChipip Enter password Mpaa RatingDpage TV RatingDpageUse Cursor K/L to select TV Rating, then press Then press Enter repeatedly to switch betweenAssociation of America Block View and BlockTV-14 Use Cursor K/L to select New Password, then press EnterChipip Enter password Confirm password Category RatingHorizontal Position, Vertical Position 5PC SettingsClock, Phase Cursor s5HDMI Audio AudioTroubleshooting 5Troubleshooting GuideDelayed behind the dialogue Check the batteries of the remote controlRefer to IR Signal Check on Entered channel numberGlossary MaintenanceInformation Atsc5Other Specifications 5General Specifications5Electrical Specification 5Cable Channel DesignationsMemo Limited Warranty