Sylvania LD155SC8 owner manual Precautions, RADIO-TV Interference, Laser Safety

Page 3

17.OBJECT AND LIQUID ENTRY - Never push objects of any kind into this TV through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the TV.

18.SERVICING - Do not attempt to service this TV yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

19.DAMAGE REQUIRING SERVICE - Unplug this TV from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power supply cord or plug is damaged or frayed.

b.If liquid has been spilled, or objects have fallen into the TV.

c.If the TV has been exposed to rain or water.

d.If the TV does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the TV to its normal operation.

e.If the TV has been dropped or damaged in any way.

f.When the TV exhibits a distinct change in performance, this indicates a need for service.

20.REPLACEMENT PARTS - When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, injury to persons or other hazards.

21.SAFETY CHECK - Upon completion of any service or repairs to this TV, ask the service technician to perform routine safety checks to determine that the TV is in proper operating condition.

22.HEAT - This TV product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

23.WALL OR CEILING MOUNTING - This TV product should be mounted to a wall or ceiling only as recommended by the manufacturer.

INTRODUCTION CONNECTION INITIAL SETTING

5Precautions

LAMP IN LCD CONTAINS MERCURY, DISPOSE ACCORDING TO LOCAL, STATE OR FEDERAL LAW.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Note to CATV system installer:

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building as close to the point of cable entry as practical.

LASER SAFETY

This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION: VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. DO NOT STARE INTO BEAM.

LOCATION: INSIDE, NEAR THE DECK MECHANISM.

IMPORTANT COPYRIGHT INFORMATION

Unauthorized copying, broadcasting, public performance and lending of discs are prohibited. This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copy- right protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

WATCHING TV OPTIONAL SETTING OPERATING DVD DVD SETTING TROUBLESHOOTING INFORMATION

Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.

3

EN

Image 3
Contents LD155SC8 Important note is located on the rear of the cabinet IntroductionImportant Copyright Information PrecautionsLaser Safety RADIO-TV InterferenceSupplied Accessories Symbols Used in this ManualTilt Stand Contents General SpecificationsRepeat A-B Playback DTV/TV/CATV FeaturesInstalling the Batteries Remote Control FunctionRear Panel Control PanelAttach this unit to the wall Attaching a Wall Mount Bracket sold separatelyConnection to Cable Box or Satellite Box ConnectionBasic Connection Antenna Cable ConnectionExternal Device Connection Component Video Cable ConnectionVideo Cable Connection Digital Audio Output Connection Video ConnectionScanning and memorizing the channels automatically start Initial SettingInitial Setup Make sure if the unit is connected to antenna or cableAuto Channel Scan Main MenuPress Setup to exit Language SelectionEnglish Español Français Volume Adjustment Watching TVChannel Selection SAP Switching Each ModeSwitching Audio Mode MainProgram Guide Screen InformationPress Display Broadcasting InformationLetterbox TV Screen Display ModeSleep Timer To Cancel the Sleep TimerBrightness Contrast Color Tint Sharpness Optional SettingPicture Adjustment Channel Add/DeleteOFF CAPTION1 CAPTION2 TEXT1 TEXT2 Press Setup to display the main menuCaption Mode CAPTION1 and TEXT1 Closed CaptionEnter 5DTV Closed CaptionBack Light Setting Chip Color TemperatureYou can adjust color temperature of the TV screen Change PasswordTV Rating Use Cursor K/L to select TV RATING, then pressTo Set the Sub Ratings Use Cursor K/L to select Mpaa RATING, then press Change PasswordEnter password again in Confirm PASSWORD. space Mpaa RatingAny other discs without compatibility indications Operating DVDDVD Functions Playable Media Unplayable MediaPause PlaybackDVD Menu Resume Playback5Zoom Step-by-step PlaybackFast Forward / Fast Reverse Slow Forward / Slow ReverseDuring playback, press Mode repeatedly until appears Search FunctionsChapter / Title Search 5Repeat A-B Playback Time SearchDirect Search 5Repeat PlaybackPress Play B to start random playback Stop mode, press Mode repeatedly until Random menu appearsProgrammed Playback Random PlaybackIntroduction On-screen DisplayCamera Angles Special SettingsSubtitle Language Audio LanguageVirtual Surround Black Level SettingStereo Sound Mode Use Cursor K/ L to adjust the black levelTo set a marker Marker SetupDefault Original Select the desired audio language DVD SettingDVD Language Setting Stop mode, press Setup to display TV SetupUse Cursor K/L to select DISPLAY, then press Display SettingUse Cursor K/L to select DVD SETUP, then press Use Cursor K/L to select CUSTOM, then pressUse Cursor K/L to select AUDIO, then press DVD Audio SettingUse the Number buttons to enter the 4-digit Parental SettingUse Cursor K/L to select PARENTAL, then press Parental LevelOthers You can change the other functionsUse Cursor K/L to select OTHERS, then press Use Cursor K/L to select YES, then press Enter Reset to the Default SettingLanguage Code List Use Cursor K/L to select INITIALIZE, then pressTroubleshooting Guide Troubleshooting Ntsc MaintenanceGlossary AtscInformation General SpecificationsElectrical Specification Other SpecificationsMemo Limited Warranty