Customized setting | JVC AV-29RS28, AV-21RX18, AV-21RX58, AV-21SX17

Customized setting (continued)

ON TIMER

You can set the TV to turn on automatically from standby mode at a set channel and time.

1 MENU FEATURES menu ON TIMER

��

� � ��

��

2 Choose the PR (channel) that you want to watch when the TV turns on. External input, AV position and any un-preset channel cannot be chosen for PR.

3 Set the ON TIMER to your desired period of time.

When the ON TIMER is set to other than 00:00, the ON TIMER is activated. You can set the period of time to a maximum of 12 hours in 15-minute intervals.

4 To off the ON TIMER, set ON TIMER to OFF.

Note: If TV is not in standby mode when ON TIMER is reach the setting time, this case is not available.

OFF TIMER

You can set the TV to turn off automatically to standby mode after a set time.

1 MENU	FEATURES menu	OFF TIMER	OFF TIMER	10

2 You can set the period of time to a maximum of 120 minutes in 10 minutes intervals.

3 When the remaining elapse time is one minute, “GOOD NIGHT!” appears on the screen.

4 You can display the OFF TIMER screen again to confirm or change the remaining time.

5 To off the OFF TIMER, select OFF or turn off the TVʼs main power.

BEEP

You can use the BEEP function to alert you during AUTO SIGNAL DETECT, Al ECO SENSOR Detect, Stereo Detect, ON TIMER/OFF TIMER operations and when some buttons on the remote control are pressed.

FEATURES menu

BEEP (Choose ON or OFF)

CHILD LOCK

You can disable the front control buttons of the TV.

MENU FEATURES menu CHILD LOCK (Choose ON or OFF)

VIDEO-2 SETTING

You can set the VIDEO-2 SETTING according to the video signal output from external devices connected to the VIDEO-2 terminal.

MENU	FEATURES menu	VIDEO-2 SETTING	(Factory setting is
			COMPONENT)
VIDEO	If a normal video signal (composite video signal) is input.

COMPONENT If a component video signal (Y/CB/CR) is input.

You must choose a setting according to the signal that you input to VIDEO-2. (If you input the VIDEO Signal or VCR Signal to VIDEO-2, you must set VIDEO-2 SETTING to VIDEO.)

For connection, \ page 4.