FUNAI CR320IL8 Supplied Accessories, Precautions, RADIO-TV Interference, Dealer Purchase from

Page 4

SUPPLIED ACCESSORIES

• Owner’s Manual

• Remote control unit

(1EMN22170)

(NE614UE)

• Batteries (AA x2) for remote control not included.

•If you need to replace these accessories, please refer to the PART NO. above the illustrations and call our help line mentioned on the front page.

•Depending on your antenna system, you may need different types of Combiners (Mixer) or Separator (Splitter). Contact your local electronics store for these items.

PRECAUTIONS

•Place your TV in a room with adequate ventilation.

•Keep your TV set away from sources of direct heat, such as heat registers or direct sunlight.

•Do not place your TV on soft surfaces, such as rugs or blankets.

•Leave enough room for air to circulate around the bottom, top and back of the set.

FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the owner’s manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4)Consult the dealer or an experienced radio/TV technician for help.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

A NOTE ABOUT RECYCLING: This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

Note to CATV system installer:

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building as close to the point of cable entry as practical.

The serial number of this product may be found on the back of the TV. No others have the same serial num- ber as yours. You should record the number and other vital information here and retain this book as a perma- nent record of your purchase to aid identification in case of theft.

Model No.

 

Date of Purchase

 

Serial No.

 

Dealer Phone No.

 

Dealer Purchase from

 

Dealer Address

 

4

EN

Page 3 Page 5
Image 4
Page 3 Page 5
Contents CR320IL8 Important Safeguards Important Safeguards Figure aSupplied Accessories PrecautionsRADIO-TV Interference Dealer Purchase fromFeatures Supplied Accessories / Precautions / FeaturesDTV/TV/CATV ChipContents Preparation for USE Contents / Preparation for USEConnection Connection to CABLE/SATELLITE BOX Component ConnectionExternal Connection Using Front A/V Connection Digital Audio ConnectionCated inside battery compartment of the remote Battery PrecautionsFeatures of digital broadcasting ControlRemote Control and Control Panel Function FunctionsInitial Settings Watching TVLanguage Selection Time ZoneSet the Auto Preset CH You can exit the initial Auto Preset menu by pressing MenuChannel Selection Watching TVDTV/ TV ChannelVolume Adjustment Switching AudioMute AudioWhen using component video cable for con- nection Screen InformationInfo Program air timeSwitching External Input When using VIDEO-2 Input jackWhen using Component Input jacks When using S-VIDEO Input jackOptional Settings Sleep TimerWatching TV / Optional Settings Menu ScreenPicture Adjustment Caption Mode C1, C2 Select Caption Using CH K/L, select CaptionClosed Caption Select DTV SET UP Using CH K/L, select DTV SET UP Select Dtvcc Using CH K/L, select DtvccText size of the displayed caption can be switched as below Press VOL Following screen is displayedOptional Settings TV Rating ChipMenu VOL Mpaa Rating Set Mpaa Rating Using the CH K/L, select the ratingTo exit the menu, press Menu Change Code Letterbox SettingsZoom Other Settings Auto Preset CHSelect Channel SET Using CH K/L, select Channel SET DTV/TVOther Settings Press VOL Using CH K/L, select Auto Preset ChdtvWhen scanning both TV and DTV at the same time Press VOL Using CH K/L, select Auto Preset CHTV/DTVUsing CH K/L or the Number buttons, select the channel Channel ADD/DELETEOther Language SelectionMenu VOL X / Y Set D.S.T. Daylight Saving Using VOL X/Y, set to on or OFF Select Time Zone Using CH K/L, select Time Zone Time ZoneBefore calling for service, check the following chart again Troubleshooting GuideMiscellaneous Miscellaneous Maintenance GlossaryAtsc NtscSpecifications Miscellaneous / SpecificationsWeight Lbs .0kg Sound output 2W, 8 ohm xLimited Warranty Warranty Statement Regarding NON Authorized RepairsDuration Limits and Exclusions
Top Page Image Contents