5Switching Each Mode
You can easily switch with the remote control to the DTV (ATSC) and TV (NTSC) or to access an external device when they are connected to the unit.
Press [DTV/TV] repeatedly to change the analog TV or the digital TV.
5Switching Audio Mode
This section describes how to switch the audio in the analog mode and how to switch the audio language in the digital mode.
TV
While receiving an MTS broadcast, press [AUDIO] repeatedly to cycle through the available audio channel.
INTRODUCTION CONNECTION
DTV / TV
Note:
ANALOG MODE
DIGITAL MODE
AUDIO | MAIN |
| |
| SAP |
| MONO |
MAIN | : Outputs |
INITIAL SETTING
•When you switch the analog mode to the digital mode, it may take a while until the digital channel selection is completed. The following TV screen is displayed while switching the mode.
NOW SCANNING
Press [INPUT SELECT] repeatedly to cycle through the input mode.
| ANALOG MODE |
| DIGITAL MODE |
INPUT | VIDEO1 |
SELECT |
|
| VIDEO2 |
| COMPONENT |
•To use the video (rear) or
•To use the video (front) input jack on the unit, select “VIDEO2”.
•To use the component video input jack on the unit, select “COMPONENT”.
SAP | : Outputs second audio program |
MONO | : Outputs |
•The current mode will automatically disappear in a few seconds.
DTV
1 Press [AUDIO] to display the currently selected language and the number of available languages.
KABC | CH |
A Day of Memories
ENGLISH 1/3
AUDIO
2 Press [AUDIO] repeatedly to cycle through the available audio languages.
ENGLISH
AUDIO
SPANISH
FRENCH
•Available languages differ depending on the broadcast. “OTHER” is displayed when the audio language cannot be acquired, or the acquired languages are other than English, Spanish or French.
•The current mode will automatically disappear in a few seconds.
Note:
• Pressing [AUDIO] does not control external audio device.
WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION
13
EN