Bell'O 8335 manual Installing the decorative End Covers

After you have prepared the holes for mounting the Wall Plate (WP), install the wall plate by inserting the four (or six) Lag Bolts (T) through the mount and into the ALLIGATOR® Anchors (U) as shown in Figures 10 and 13. After checking that the wall mount is level, tighten all lag bolts fully, but be careful not to over-tighten.

Figure 13

T

U

WP

3"(76mm) minimumholedepth

Concrete

Installing the decorative End Covers

Even though your TV hides most of your wall mount from view, from the sides you can probably still see the ends of the bracket. This kit includes decorative End Covers (EC) to make your bracket installation look clean and finished. To install the end covers, simply line up the cover with the end of the bracket, and press into place. Look for two holes in the frame of the bracket which the end cover inserts into, as shown in Figure 14.

Figure 14

WP

EC

English