PC Adjustment

COMPUTER MODE

This Projector can automatically tune to the display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be tuned by the Multi-Scan system of this projector. If this happens, the projector cannot reproduce a proper image and the image may be recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.

This projector has a PC ADJUSTMENT function, to enable you to precisely adjust several parameters to match with those special signal formats. This projector has five independent memory areas to memorize those parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use it.

Note : This PC ADJUSTMENT function cannot be operated when “RGB,” “HDTV1035i” or “HDTV1080i” is selected on the SYSTEM MENU (P22 and 23).

1	Press the MENU button and the ON-SCREEN MENU will
	appear. Press the POINT RIGHT/LEFT buttons to select PC
	ADJUST	and press the SELECT button. Another dialog box
	“Where to reserve” Menu will appear.
2	In this dialog box, you can store the parameter into the area from
	“Mode 1” to “Mode 5.” When memorizing the new computer
	parameter, select the Mode with the message “Free” by pressing
	the POINT UP/DOWN buttons and the SELECT button. To
	change the parameters of the Mode previously set, select the
	Mode with “Stored.”
3	When the Mode is selected, Parameter adjustment dialog box
	appears. Move the arrow to the item that you want to change by
	pressing the POINT UP/DOWN buttons, and adjust each item to
	match with your computer. To change the value, press either
	the POINT RIGHT / LEFT button.
	Refer to the next page for adjusting each item.
4	Move the arrow to “Stored” and press the SELECT button. The
	parameter is memorized in the selected Mode.
5	To activate the Mode manually adjusted in this PC
	ADJUSTMENT Menu, select the Mode at the SYSTEM SELECT

Menu. (Refer to page 22.)

This Mode has parameters being stored.

The Vacant Mode.

Manual set Computer

Mode (1 to 5).

Closes the PC

ADJUSTMENT Menu.

Press the SELECT button to set Full screen function on/off.

Press the POINT RIGHT/LEFT button(s) to adjust the value.