Maintenance and Troubleshooting
Lamp Replacement
Lamp door | Lamp Screw |
1.Remove the lamp screw from the lamp door.
2.Remove the Lamp Door.
3.Remove the two Phillips head screws that hold the lamp in place.
4.Grasp the handle on the top of the lamp and pull the lamp straight up out of the projector.
5.Slide the replacement lamp into place and press firmly to seat the lamp.
6.Reinstall the screws removed in step 3.
7.Reinstall the lamp door correctly and tighten the screw on the lamp door.
8.Please see page 60 for resetting the lamp timer.
CAUTION
WARNING
The lamp and inside of the projector become very hot while the projection lamp is lit. Allow the projector to cool for at least 15 minutes prior to opening the lamp door.
Do not touch the bulb. Touching the bulb will greatly decrease the life of the lamp and could cause the bulb to explode.
49