Emerson DTE316 manual Important Safety Instructions, Ventilation

Page 5
ELECTRODE SYSTEM
ELECTRIC
SERVICE EQUIPMENT

IMPORTANT SAFETY INSTRUCTIONS (CONTINUED)

9.VENTILATION

Slots and openings in the cabinet and in the back or bottom are provided for ventilation, to ensure reliable operation of the product and to protect it from overheating. These openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should never be placed near or over a radiator or heat source. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to.

10.POWER SOURCES

This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instructions.

11.GROUNDING OR POLARIZATION

This product is equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

12.POWER-CORD PROTECTION

Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

13.LIGHTNING

To protect your product from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges.

14.POWER LINES

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

15.OVERLOADING

Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

16.OBJECT AND LIQUID ENTRY

Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any

type of liquid on the product.

17.OUTDOOR ANTENNA GROUNDING

If an outside antenna is connected to the product, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the

information with respect to proper grounding of

the mast and supporting structure, grounding of the lead-in wire to an antenna discharge product,

size of grounding conductors, location of antenna

discharge product, connection to grounding electrodes and requirements for grounding electrodes. S2898A

18.SERVICING

Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

19.REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

20.SAFETY CHECK

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

21.WALL OR CEILING MOUNTING

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

4

Image 5
Contents Page Contents Page Read Instructions Ventilation Important Safety InstructionsUSE Under Supervision of AN Adult DUE to Long Cord Power SourceFCC Warning Catv Location of ControlsSpeaker Battery Precautions Remote ControlFor Subscribers to Scrambled Cable TV Service or Satellite For Subscribers to Basic Cable TV ServiceFAQ Cable CATV/SATELLITE ConnectionsExternal AUDIO/VIDEO Connections FaqsAntenna Connections Connecting the ROD Antenna not SuppliedOutdoor Antenna Connections OUT Door VHF/UHF Antenna Connectionantenna not SuppliedCables not Included VCR ConnectionsSetting the TV Menu Setting the TV MenusPicture Preset Turn on the TVSetting the Brightness Setting the Picture MenuSetting the Picture Settings Setting the Sharpness Setting the ContrastSetting the Color Setting the Preset Menu Setting the TintSetting the Reception Setting the ChannelSetting the ADD/DELETE Setting the AFC Setting the Auto SearchSetting the Fine Setting the on Time Setting the Clock MenuSetting the Clock Setting the Preset Setting the OFF TimeSetting the Attention Color System Setting the Function MenuSetting the Parental Ctrl Setting the LanguageSetting the C.CAPTION Display TV/AV ButtonMute Sleep ButtonChip Button CCD Button What is Closed CaptioningCheck the following before requesting service Troubleshooting GuideReception Disturbances Authorized Service Dora the EXPLORER- Model DTE316 Limited WarrantyAccessory SpecificationsGeneral TV SectionPart NO. DTE316