Barco MFCD 1219 (TS) user manual Settings menu

Page 26

On-screen display (OSD)

Settings menu

Function	Description


OSD Settings	Allows to switch the display power management
submenu	system on/off. See note below.

Factory Reset	Allows to to reset all display parameters to the
submenu	factory default settings.

Language sub-	Allows to change the OSD language.
menu

DPMS submenu	Allows to switch the display power management
	system on/off. See note below

LED submenu	Allows to switch the power LED on/off.

Note: The DPMS system will power down the display when the connected computer is left idle for a certain time.

Barco recommends to switch DPMS on to prevent image burn-in (image retention) on the LCD panel.

26

Image 26

Contents Mfcd 1219 TS This page intentionally left blank Copyright notice Table of Contents FCC Compliance Information display PrefaceTrademarks Canadian notice Disposal Information Safety InstructionsEnvironmental information General RecommendationsElectrical shock Type of protection electrical Degree of safety flammable anesthetic mixturePower connection Ventilation InstallationWater and moisture Optimize the lifetime of your display This apparatus conforms toNational Scandinavian Deviations for Cl Use a screen saver to avoid image retentionMaximize Quality Assurance Understand pixel technologyEnhance user comfort Introduction Power SavingOverview Multi-scan capabilitiesPackage contents Controls and connectors Wall mounting InstallationPrecautions Remove the panel from the footFix the mounting plate to the wall Place the panel on the mounting plateConnecting the signals Starting up To connect the video & sync signalsTo connect the power Proceed as followsInstallation Touch panel software Install the softwareMediCal QAWeb Agent software On-screen display OSD How to use the OSDTo change an OSD setting, proceed as follows Description of the menu items Input Selection menuBrightness / Contrast menu Color Menu Geometry menu Settings menu OSD Settings submenu To unlock the Controls, proceed as followsInformation menu Cabinet MaintenancePanel Appendix a Possible resolutions Following modes are preset as factory defaultsAppendix B Technical specifications Bus Connector for DC 12V, 4.5A input This page intentionally left blank Appendix B Technical specifications Appendix B Technical specifications K5904239-00 August