Barco MFCD 1219 (TS) Fix the mounting plate to the wall, Place the panel on the mounting plate

Page 16

Installation

2.Firmly press down the push-button (9) with one hand while carefully lifting the panel up with the other hand.

3.Remove the panel from the foot.

Step 2: Fix the mounting plate to the wall

1.Screw the mounting plate to the wall with the 4 supplied screws

(A).

A

2.Slide back the locks at both sides of the mounting plate (B). In that way, you can secure the panel to the mounting plate after placing the panel.

B

Step 3: Place the panel on the mounting plate

1.Place the panel on the mounting plate (C). If you want to secure the panel to the mounting plate, place the panel in the frontmost notches.

16

Image 16

Contents Mfcd 1219 TS This page intentionally left blank Copyright notice Table of Contents Trademarks PrefaceFCC Compliance Information display Canadian notice Safety Instructions Environmental informationDisposal Information General RecommendationsPower connection Degree of safety flammable anesthetic mixtureElectrical shock Type of protection electrical Water and moisture InstallationVentilation This apparatus conforms to National Scandinavian Deviations for ClOptimize the lifetime of your display Use a screen saver to avoid image retentionEnhance user comfort Understand pixel technologyMaximize Quality Assurance Power Saving OverviewIntroduction Multi-scan capabilitiesPackage contents Controls and connectors Installation PrecautionsWall mounting Remove the panel from the footFix the mounting plate to the wall Place the panel on the mounting plateConnecting the signals To connect the video & sync signals To connect the powerStarting up Proceed as followsInstallation MediCal QAWeb Agent software Install the softwareTouch panel software To change an OSD setting, proceed as follows How to use the OSDOn-screen display OSD Description of the menu items Input Selection menuBrightness / Contrast menu Color Menu Geometry menu Settings menu OSD Settings submenu To unlock the Controls, proceed as followsInformation menu Panel MaintenanceCabinet Appendix a Possible resolutions Following modes are preset as factory defaultsAppendix B Technical specifications Bus Connector for DC 12V, 4.5A input This page intentionally left blank Appendix B Technical specifications Appendix B Technical specifications K5904239-00 August