SCEPTRE X23 HDTV User Manual
Problems
PICTURE ONLY
NO AUDIO
REMOTE
CONTROL
DOES NOT
WORK
CANNOT
RECEIVE SUFFICIENT CHANNELS THROUGH THE ATSC/NTSC TUNER
NO COLOR
WEAK SIGNAL OR NO PROGRAM SYMBOL ON SCREEN
TV CHANNELS ARE BLOCKED
UNIVERSAL REMOTE CODE
THE TV TURNS ON OR OFF SLOWLY AND THE SCREEN SHOWS UP SLOWLY
NO SOUND ON PC
Solutions
Make sure the audio cable is connected. Readjust your volume via the remote control.
The TV’s tuner signal must not be lower than 65 dB. Turn off the TV, unplug it from the socket. Remove the batteries out of the remote for 30 minutes. Press the remote buttons and the power button randomly for a good 2 seconds, and then reinstall the batteries. Try the remote to see if it works.
The TV’s remote sensor is also housed in the same place as the power indicator light. Please make sure there is line of sight from the remote control’s front sensor to the remote sensor of the TV.
The TV’s tuner signal must not be lower than 65 dB. Change the direction of your antenna and rescan your channels. If you have cable call up your cable company and ask about signal strength of your local cable.
Please adjust your picture setup and make sure the saturation and the RGB are not turned all the way down.
The TV’s tuner signal must not be lower than 65 dB. Check your signal.
The TV’s tuner signal must not be lower than 65 dB. Change the direction of your antenna and rescan your channels. If you have cable call up your cable company and ask about signal strength of your local cable.
Check your auto lock function’s settings inside the OSD. You may have locked up some channels but forgot about them. This TV follows SONY’s universal remote code. Please check your hand book for SONY’s codes then apply them.
This TV is a High Definition liquid crystal display panel TV. It requires a few more seconds than normal TVs to power up and show the picture.
Make sure you have a 3.5 mm
- 101 -
www.SCEPTRE.com