Sceptre Technologies X460 user manual FCC Compliance Statement, European Notice

Page 53

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: This device may not cause harmful interference

This device must accept any interference received, including interference that my cause undesired operation.

Please Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Caution: To comply with the limits for an FCC Class B computing device, always use the signal cord and power cord supplied with this unit.

The Federal communications Commission warns that changes or modifications to the unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

European Notice

Products with the CE marking comply with both the EMC Directive (89/336/EEC), (93/68/EEC) and the Low Voltage Directive (72/23/EEC) issued by the Commission of the European Community.

- 53 -

www.SCEPTRE.com

SCEPTRE X460 HDTV User Manual

Page 52 Page 53
Image 53
Page 52 Page 53
Contents Dear Sceptre Customer Important Information Safety Instructions Safety Instructions Page External Television Antenna Grounding Television Antenna Connection ProtectionOpening the Package Package ContentsInstallation Removing the Stand Table of Contents Rear View Mounting Pattern Identifying Front and Rear PanelFront View Side Control Buttons Please Note Rear View ConnectionsSceptre X460 Remote Control Installing Batteries to the Remote Control If You Have Digital Cable without Cable Box or Antenna… Connection SuggestionsConnecting DVD Player with Component YPbPr… Connecting Wii with Composite… Connecting Cable or Satellite boxes with HDMI… Connecting to a PC with VGA and 3.5 mm minijack … Connecting a Digital Audio Receiver with Coax SPDIF… Switching Sources If You’ve Connected Antenna or Cable to the TV… Ready to Watch Some TV?Starting up the Hdtv Page Via TV Side Panel Buttons Via Remote ControlOSD On Screen Display Controls Picture OSD On Screen Display OptionsUnder PC VGA there are only full and dot by dot mode Advance Picture Settings Sound Other Settings AVL Under Other Settings Channel III. Channel Setting Parental Setup III. Clock Others USB Connection Explained Detailed ExplanationsMedia Setting Rating Explained Closed Captioning digital and analog ExplainedMpaa Normal Aspect Ratio ExplainedTo ADD to the Favorite List Shortcuts to Browsing ChannelsCleaning the bezel and remote control How do I clean the TV ?Problems Solutions TroubleshootingTV Channels are Switching a Call Us If You Need Help Illustration Specification4NTSC/ATSC Limited Product Warranty Warranty Service Disclaimer, Trademarks, & Copyright Information European Notice FCC Compliance Statement
Top Page Image Contents