If the vent requires cleaning, use a soft bristle brush.
Rinse all components well with drinking quality water and allow them to air dry out of direct sunlight.
Weekly
Handwash the headgear by gently rubbing in warm (30°C) water using mild soap or diluted dishwashing detergent. Rinse the headgear well and allow it to air dry out of direct sunlight.
Cleaning the Mask between Patients
The Mirage Liberty should be disinfected or sterilised when used between patients.
Detailed disinfection and sterilisation instructions are available from the ResMed website, www.resmed.com/masks/sterilization, and must be consulted before multipatient use.
Reassembling the Mask
See section D on the illustrations sheet.
Before reassembling the mask, check that all components are clean and dry. Check that the valve is not damaged, distorted or torn, and that none of the other components are broken or cracked. Replace any parts that are damaged. Flexible PVC contains elements that can be detrimental to the materials of the mask. If flexible PVC tubing is used continuously, the attachment port should be inspected for cracking. Replace any parts that are damaged.
Refer to “Ordering Information” for
1Attach the nasal pillows to the mouth cushion:
a Push the nasal pillows through the holes in the mouth cushion
around the mouth cushion holes
cCheck that the tabs on each pillow fit into the corresponding notches on the cushion
2Attach the mouth cushion to the frame:
a Position the cushion alignment guide between the two nasal pillows and line up the triangle symbols on the bottom of the mask frame with those on the mouth cushion.
b Press the mouth cushion into the groove in the frame
3Insert the ports cap
4Clip the upper headgear clips onto the mask
English
5