AOC FT920 user manual Front Panel Control see figure, Power Indicator, HOW to Adjust a Setting

Page 10

FRONT PANEL CONTROL (see figure 3)

Standby Switch: When pressed, the monitor enters the off mode, and the LED turns orange. Press again and hold to restore normal status.

Power Indicator :

Green — Power On mode. Orange — Off mode.

Shuttle Knob : The Shuttle Knob is used to control the monitor functions. Rotate to switch functions or adjust settings. Press to select or execute a function.

HOW TO ADJUST A SETTING

1.Press the Shuttle Knob or OSD Key to make the OSD window appear. See figure 4.

2.Rotate the Shuttle Knob to select the desired function.

See figure 4.

3.Press the Shuttle Knob again to select the function that you want to adjust.

4.Rotate the Shuttle Knob to change the settings of the current function.

5.When the OSD window is active, it shows the input signal timing. The "H" stands for the horizontal frequency and "V" for the vertical frequency.

6.To exit and save, either press the OSD Key, select the exit function, or leave the monitor alone for 10 seconds.

If you want to adjust any other function, repeat steps 2-4.

Image 10
Contents Flat CRT By Envision Peripherals, IncChecking the Contents of the Monitor Package Page Precautions Plug & Play DDC1/2B Feature Using the Right Power CordTechnical Supportfaq Power Source Installation Instructions Swivel BasePower Cord To attach the swivel base to the monitor, do the followingOperating Instructions General Instructions Installing and Removing the Swivel Base HOW to Adjust a Setting Power IndicatorFront Panel Control see figure Adjusting the Picture see figure TrapezoidSpecification CRTPreset Timing Table Connector Pin Assignment