AOC FT920 user manual Installation Instructions Swivel Base, Power Cord, Power Source, Video Cable

INSTALLATION INSTRUCTIONS

SWIVEL BASE

To attach the swivel base to the monitor, do the following:

•Carefully turn the monitor on its side or upside down. (see figure 1)

•Locate the cavities at the bottom front of the monitor.

•Insert the pegs on the swivel base into these cavities. Push the swivel base forward until the swivel base locks in place.

•To remove the swivel base, hold the bottom of the swivel base, then push it out.

POWER CORD

Power Source:

1.Make sure the power cord is the correct type that required in your area.

2.This monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required).

3.Connect the power cord into your monitor’s power input socket, and then plug the other end into a 3-pin AC power outlet. The power cord may be connected to either a wall power outlet or the power outlet socket on your PC, depending on the type of power cord supplied with your monitor.

VIDEO CABLE

Connecting the Video Cable: the monitor comes with a built-in video cable. Plug the signal cable′s 15-pin connector into the computer's video port and tighten the two screws on the cable connector. (see figure 2)

Caution: Don’t bend the signal cable, otherwise it will break the inner wire.

Connecting the Power Cord: Plug the power cord into the monitor's AC power socket. Then plug the power cord into a grounded AC outlet or UL-approved power strip or the power output socket on your PC.

Caution: If the AC outlet is not grounded, install the proper grounding adapter (not supplied).